Changing the Extender ID | Onkyo USR-5RF manual

Getting the Maximum out of it

Changing the Extender ID

1.Make sure the Extender ID button is active. The button is active when the button label is white.

2.Press the + and – action buttons to change the Extender ID.

The remote controller offers 16 Extender ID’s.

5.Tap Accept to save the RF IR settings for the selected device.

or

Tap Cancel to return without changing the RF IR settings for the selected device.

6.Repeat instructions 3 to 5 for all devices for which you want to change the RF IR settings.

7.Tap Close.

The remote controller switches back to Use mode. The remote controller is configured to operate the devices you have set with RF signals.

8.Try the devices which you just changed the RF IR settings.

Note:

There is a possibility that a device does not respond properly when operated with RF signals. This is mostly due to IR signals that cannot be properly transmitted as RF signals.

In that case, you have to reconfigure the remote controller to operate the device with IR signals again.

35

Image 35

Onkyo USR-5RF instruction manual Changing the Extender ID, Try the devices which you just changed the RF IR settings

Contents

USR-5RF Care Precautions Table of contents Operate your components Quick StartInsert batteries Touch the screen to start Quick reference Quick reference Modes Quick reference Introduction Intelligent Remote ControllerDirect-access buttons Which Buttons Can Be Programmed? Left and Right buttonsTouchscreen buttons AA batteries Charging the Remote Controller Optional recharging dock Define the Brand of Your Device Activate the remote controllerGetting Started Tap Next Defining brands by selectingSelect Yes to define the brand of the device to operate Select your brand from the list Navigate through the list of brands Select a code set from the list Tap Search Defining brands by searching Via the Device menu Select a DeviceVia the Home menu Scrolling Using touchscreen buttonsSending commands Operate a Device IR commands Device pages Use the Left and Right button to adjust the setting Adjust the SettingsTouch and hold the remote controller icon for a few seconds Tap the button of the setting you want to adjust Third setup panel Second setup panel Working with Modes Getting the Maximum out of itIntroduction Tap Tap the mode you want to useTo hide the Mode menu Programming control panel buttons Programming Buttons Make sure the device tab is active Programming direct-access and Left/Right ButtonsProgramming device items Edit the label Labeling Buttons and Menu ItemsLabeling a button Complete instruction 4 to 6 Labeling a button on Labeling a menu item Moving menu items Adding and Moving DevicesAdding devices Deleting a button or button function Delete and restoreDelete Tap the item you want to restore Restore Recording macros Recording Macros and Setting Timers Editing macros Setting timers Tap Create Timer Group or Create Macro Group Editing timersOrganizing macros and timers into groups Edit the timer Press the Left button to close the timer Using the remote controller with Radio Frequency Tap RF Changing the remote controller’s RF IR SettingsSwitch to RF IR mode by using Mode button Changing the Extender ID Try the devices which you just changed the RF IR settings Press the + and action buttons to change the Channel Switch back to RF IR modeSelect a device that is set with RF signals Choosing Another Channel With ChadEdit you can ChadEdit System requirements General Problems Programming Problems Troubleshooting Recharging Problems How do I revert to the original configuration? Can I program a button to execute more than one command?How do I program source switching? How do I reset the Remote controller? Overview of Symbols Specifications Onkyo U.S.A. Corporation