Panasonic AG-HPG20, AG-HPG20E, AG-HPG20P Clip management, 2 Press, Deleting clips, Selecting clips, – “DELETE”, and press, 3 Press [MENU/MODE CHK], “cross cursor operation”, To release the selection

Clip management

Selecting clips

When performing operations on the thumbnail display screen, select the clip which will be the target of these operations as follows.

1 Using , , or , move the cursor (yellow frame) to the target clip.

To move the cursor to left or right, use or . You can also use or by pressing and holding [ALT/3].

To move the cursor up and down, use or by pressing and holding [ALT/3].

This operation on the rest of the pages in this

manual is referred to as “cross cursor operation”.

2 Press .

A bluish-green frame now appears at the clip where the cursor is positioned to indicate that the clip has been selected.

•To allocate functions to the USER buttons, refer to “USER button” (Page 32).

•[ALT/3] does not work when ALT function is not allocated to [ALT/3].

•By repeating steps 1 and 2, you can select a multiple number of clips.

•If you select a clip and move the cursor to another clip, and then press while pressing and holding [ALT/3], you can select from the last selected clip until the clip at the cursor position at a time.

•To move from one page to another, press or of .

To release the selection1 Move the cursor to the selected clip, and press again.

The selection is released.

•By pressing [EXIT/2] while pressing [ALT/3], you can cancel the selection of the selected clips all together.

Deleting clips

You can delete unwanted clips from the P2 card by proceeding as follows.

1 Display the thumbnail display screen.

2 Select the clips to be deleted.

3 Press [MENU/MODE CHK].

4 Using , and , select “OPERATION”– “DELETE”, and press .5 Select “YES”, and press .6 When the completion message has appeared, press “OK” ().

•It may not be possible to delete clips for which the X defective clip indicator or ? unknown clip indicator is displayed.

40