CANNOT RE-CONNECT!

Clips cannot be reconnected because content which is contained on no more than one card has been selected or because of a similar reason. Check the selected content.

CANNOT RECOGNIZE HDD!

The connection destination target cannot be recognized correctly. Turn the power of the hard drive off and then back on or change the connected hard drive.

CANNOT REPAIR!

You thought the clip would be repaired and it was tried to be repaired, but could not actually be repaired. Check the selected clip.

CARD FULL!

The P2 card or SD card is full. Insert media with free space.

CARD IS EMPTY! CANNOT COPY! The P2 card whose data is to be copied is blank. A blank card cannot be copied because there is no data to be copied.

COPY INHIBITED

The input signals are copy-guarded so they cannot be recorded correctly.

■D

DIR ENTRY NG CARD

The directory structure on the P2 card is not supported.

Operation continues. However, back up data on the P2 card as soon as possible, and format the card before using it again.

■F

FORMAT ERR!

The card does not comply with the P2 standard.

■H

HDD CAPACITY FULL!

The hard drive does not have enough free memory. Use a new hard drive or formatted hard drive since the connection destination target does not have enough remaining memory.

HDD DISCONNECTED!

The hard drive has been disconnected. Re-establish the USB connection. If the hard drive still fails to operate properly, turn its power off, and then turn it back on.

■I

INCOMPATIBLE CARD

The card complies with the different standard and so it cannot be used.

■L

LACK OF REC CAPACITY!

There is not enough memory on the card for the clips to be recorded. Insert a card with enough memory on the card for the clips to be recorded.

LOW BATTERY

No operation is possible because the battery charge is depleted.

■M

MISMATCH COMPONENT!

Data cannot be copied because the copy source and copy destination P2 cards have different model numbers. Either use P2 cards of the same model number, or copy data one clip at a time.

MISSING CLIP!

Shot marks cannot be added to clips that span across multiple cards if all cards are not inserted to the unit's slots. Insert all the cards containing the consecutive clips.

■N

NO CARD!

No P2 card or SD card has been inserted.

Insert media which is supported.

NO COPY TO SAME CARD!

 

 

Data cannot be copied because the same

 

 

 

card is being specified for the copy source

 

 

 

and copy destination. Copy the data onto

 

 

 

a card which does not contain the selected

 

 

 

clip.

Displays

 

 

 

 

 

NO REPAIR CLIP!

 

 

The clip to be repaired has not been

■P

selected.

 

 

 

 

 

 

 

 

P2 CARD IS UNFORMATTED!

 

 

 

The P2 card has not been formatted. Use a

 

 

 

P2 card which has been formatted.

 

 

 

 

 

 

PLEASE FORMAT P2 CARD!

 

 

 

When importing a partition from a hard disk

 

 

 

to a P2 card, only use a freshly formatted

 

 

 

P2 card to copy to. After formatting the card

 

 

 

using the P2 device, initiate copying again.

 

 

 

 

 

83