Screen displays (continued)

■R

RUN DOWN CARD

The maximum number of overwrites on the P2 card has been exceeded.

Operation continues. However, recording or playback may not operate correctly. It is recommended that you replace the P2 card with another one.

■T

TOO MANY CLIPS!

Too many clips have been selected. Reduce the number of clips which have been selected.

TOO MANY PARTITIONS!

There are too many partitions. The maximum number of partitions available on the hard drive is 23 in the USB HOST mode. Use a new hard drive or formatted hard drive.

TOO MANY TARGETS!

A multiple number of devices have been connected. Only one USB hard drive must be connected. Make sure if a hub, multi-HDD, etc. are not used. After disconnecting the unnecessary devices, turn the power of the required device off and then turn it back on.

TURN POWER OFF!

Turn the power off, and turn it back on for use.

■U

UNKNOWN CONTENTS FORMAT!

A contents version mismatches or this is a clip for which the unknown clip indicator is displayed. Match the unit and contents versions.

UNKNOWN DEVICE CONNECTED!

A DVD drive or other devices which are not supported have been connected. After disconnecting the unnecessary devices, turn the power of the required device off and then turn it back on.

■V

VERIFICATION FAILED!

A mismatch was found by verification after copying. Copy the data again.

■W

WRITE PROTECTED!

The P2 card or SD card is write-protected. Insert media on which data can be saved.

Error displays

Errors are displayed when trouble has occurred in the unit, P2 card, etc. If the error persists even after turning the power off and back on, depending on what the error message says, replace the card or contact your dealer.

■Number1394 INITIAL ERROR

(Connection trouble)

There is trouble in the DVCPRO/DV input/ output connector (IEEE1394) connection or the signals are not being input or output correctly. Check the connections between the unit and the other device. If the error display is not cleared, turn the power off and then back on.

1394 INPUT ERROR (OTHER FORMAT) The input signal format differs from the system format.

■C

CANNOT PLAY

This appears when trouble has occurred during playback.

CARD ERR (1) (2) (1/2)

(Trouble with the P2 card in the slot corresponding to the number shown)

•If the warning persists, turn off the power.

•If the warning persists even when recording is initiated again, replace the existing card with another one.

■R

REC WARNING

This appears when trouble has occurred during recording. Initiate the recording again. If the warning is still displayed, consult your dealer.

■S

SYSTEM ERROR

This appears in the following abnormal situations.

•This appears when trouble has occurred in the system. Turn the system’s power off and then back on.

•This error may appear with some connected hard drives. Check the connected hard drive.

P2 MICON ERROR (no response from P2 microprocessor), P2 CONTROL ERROR (P2 control trouble)

■T

TURN POWER OFF

This appears when trouble has occurred because a card was ejected while its data was being accessed. Turn the system’s power off and then back on.

84