Panasonic BB-HCM331A Setting, Description, number on your network in the order from 50000 to

Operating Instructions

	Setting	Description
Allow Access from		• Allow Access from the Internet setting automatically
the Internet		configures the router's Port Forwarding setting (some
(Automatic Setup		routers call it "Address Translation", "Static IP
Only)		Masquerade", "Virtual Server" or "Port Mapping"). To
		enable Internet access to the camera, check [Yes]. In this
		case, the camera automatically searches the unused port
		number on your network in the order from 50000 to 50050.
		To disable Internet access to the camera, check [No].
Network		• If you prohibit the Setup Program from changing the
Configuration from		network settings, clear the check box.
Setup Program
(Static/DHCP Only)
Port Number		• The port number is 80 by default. When you use multiple
(Static/DHCP Only)		cameras with a router on your network, each camera must
		be assigned its own port number (see page 27 "1.9
		Connecting the Camera to a Router Not Supporting
		UPnP™ (IPv4 Only)" in the Installation/Troubleshooting).
		• Do not set the following port numbers.
		E.g., FTP: 20 and 21, Telnet: 23, SMTP: 25, DNS: 53,
		POP3: 110, HTTPS: 443, ICQ: 4000 and IRC: 6661—
		6667.
		• Enter only the number (1—65535).
		• Some ISPs do not allow you to use port 80. Ask your ISP
		or network administrator about the accessible port number
		over the Internet.
•	IP address	• If your ISP or network administrator specifies the IP
•	Subnet Mask	address and subnet mask, enter them in each data field.
(Static Only)		• If you use the camera on the LAN, set the IP address in the
		same class as your PC (see page 132).
		• Set 4 digits (0—255) and 3 periods such as
		"192.168.0.253". But "0.0.0.0" and "255.255.255.255" are
		not available.
Host Name		• If your ISP uses the DHCP function which automatically
(DHCP Only)		assigns the IP address to the camera, enter the ISP-
		assigned host name. (Host name may be used as an
		authentication.)
		• Enter ASCII characters for the host name (see page 140).
		But [Space], ["], ['], [&], [<] and [>] are not available.

42