Panasonic CF-30KTPAXxM Assembly of LCD Unit Only the model who doesnt have T/S, Insert the CN

■Assembly of LCD Unit (Only the model who doesn't have T/S)

LCD drop holder Insert

<Notes>

1.Apply the load when attaching the attaching parts. 20 to 30N (2 to 3Kgf)/cm2

2.Reusing the attaching parts is impossible.

Fix with Screws in order of the rear number of No.

Ex.) Fix in order of Screw-1 to Screw-2.

Torque of tightening Screw :0.45 ± 0.02N·m( 4.5 ± 0.2kgf·cm) Connect the LCD Cable.

0~1

Screw Set

CAUTION	S1:Insulation S2:Bitten S3:Sharp Edge
	S4:Part No. Check S5:Other

Put the side of the socket pin up and insert it into the CN of LCD.

Tape-2 Attach. 3~5

2~4

Insert the CN.

	NEW GPS	Do not allow the tape to run over the LCD reflection plate.
	Sheet	0~2			71~73
Fix the Connector.. Attach.			Top Case		59~61
		Opalescent Screws
Top Case	4~6	outer shape line	Sheet-5 Attach.		4~6
		0±1	Top Case		Top Case
Sheet-1 Attach.			Sheet-4 Attach.
	62~63	Top Case Sheet-2 Attach.			Sheet-3 Attach.
7~9	5~7	Confirm the Cable is separated(3 mm or more).
		Confirm the sub material tape is wrapped.		0~1	0~1
		2~4
		Insert the CN.		LCD cable	Avoid catching.
6~8
		Avoid catching of
	41~43		Screw-2	BUSH Set	16~18
		the INV Cable.		Screw-1
Tape-1 Attach.			Tighten	Tighten
				Ensure the Cable does not run over the inverter.
			S2

	Process the Cable from the		S2
Set LCD cable Bush	inverter to the bottom side.	Avoid catching the
into the rib firmly.	Process the LCD Cable on it.	Cable in the Cabinet
			Avoid catching the Cable in the Cabinet

9-15