Panasonic CF-30KTPAXxM service manual Setting the FPC HDD BAT, Preparation of HDD FPC ASS’Y, Batt

9.2.12. Setting the FPC HDD BAT

1.Fix the FPC HDD BAT using the Screw <N16>.

2.Connect the 2 Cables to the 2 Connectors (CN7,CN8).

3.Connect the Cable to the Connector (CN800).

4.Attach the PAD Protect Sheet.

5.Connect the Cable to the Connector (CN9).

6.Attach the Tape.

7.Connect the 2 Cables to the 2 Connectors (CN10,CN26).

8.Attach the Tape.

9.Attach the Antenna Cable Sheet on the Main PCB.

10.Fix the HDD FPC BAT using the 3 Screws <N29> (No1 to No4).

Note:

Tighten the Screws in the numbered order (No1 to No4).

Screw <N16>: DRQT26+E5FKL

Screw <N29>: DRQT26+E3FNL

to Connector (CN8)
to Connector (CN7)
<N16>
FPC HDD BAT
No.2
<N29>
No.1	to Connector (CN800)
<N29>	Antenna Cable
No.3
	Sheet
<N29>
	to Connector
Tape	(CN26) Connector
HDD Cable Cover	(CN10)
Pad Protect	Connector
Sheet
Connector	(CN26)
(CN8)
	Tape
Connector
(CN7)	Connector
	(CN9)
Pad PCB	Connector
	(CN800)

■Preparation of HDD FPC ASS’Y

		S1:Insulation S2:Bitten	S3:Sharp Edge		Tape Attach based on the
CAUTION					stiffening plate side
		S4:Part No. Check S5:Other			and fold back to the back side.
					(Avoid wrinkle or floating.)
					Apply the load. 2 to 3 kg
	Fold mountain based
	on the white line.
	R0.5 to R1
	Do not apply the load
	on the folding part.
	Do not forget folding			0~0.5

Tape

Tape Attach based on the

stiffening plate side and fold back to the back side.

(Avoid wrinkle or floating.) 1~3 Apply the load. 2 to 3 kg

Fix with Screws in order of the rear number of No. Ex.) Fix in order of Screw-1 to Screw-2.

Screw-2 Screw-1

Tighten Tighten

BATT	BATT
Guide
	CN PIN
Set
	Set

Do not forget folding

BATT CN PIN Cushion

Set

Tape

S3

Torque of tightening Screw :0.19 ± 0.02N·m( 2.0 ± 0.2kgf·cm)

9-28