Panasonic CF-30KTPAXxM service manual Setting the SD PCB, Express Card Pcmcia Card

9.2.9.Setting the SD PCB, Express Card

and PCMCIA Card

1.Fix the PCMCIA Card using the 4 Screws <N22> (No1 to No4).

2.Fix the Express Card using the 4 Screws <N22> (No1 to No4).

3.Fix the SD PCB using the 2 Screws <N5> (No1 to No2).

No.1	No.3
<N22>
No.2	<N22>	No.4
<N22>	<N22>
		No.1
		<N22>

PCMCIA Card

No.2

<N22>

No.4

<N22>

No.3

<N22>

Express Card

No.2

<N6>

No.1	SD PCB
<N6>

Note:

Tighten the Screws in the numbered order (No1 to No4).

Tighten the Screws in the numbered order (No1 to No4).

Tighten the Screws in the numbered order (No1 to No2).

Screws <N6>: DRQT26+E4FKL

Screws <N22>: DXQT2+G4FNL

■Preparation of PCMCIA Card Connecter

<Notes>
1.Apply the load when attaching the attaching parts. 20 30䰚䯴2	3Kgf䯵/cm2
Reusing the attaching parts is impossible

CAUTION

S1:Insulation S2:Bitten S3:Sharp Edge S4:Part No. Check S5:Other

PCMCIA Card

S1 Paste

㪪㪿㪼㪼㫋㫄㪼㫋㪸㫃㩷㫇㪸㫉㫋㩷㫀㫅㫊㫌㫃㪸㫋㫀㫆㫅

CN Tape S

CN Tape L

/CVEJVQVJG	CN Plate	The end of metal
'PFHCEG		fittings is mixed
		with a bend.	The fact which
		$QPFGFUWTHCEG	doesn't paste out of
			metal fittings (tape)
			Sheet 0 +1
1±1		CN Tape L
CN Sheet	CN Tape S
	It's stuck on according to the interior angle of the metal fittings.
I bend and stick on together
with a part.
CN Sheet(Dotted line)		CN Sheet	Don't peel off released
			paper in an underside.
		After bend and keep,
		released paper is peeled
		off and CN sheet
		is paste.
		CN Plate
		CN Tape L

After bend and keep, released paper is peeled off and CN sheet is paste.

Completion

The surrounding tape and a seat are stuck on.

CN Sheet

The adhesion which is oil in metal fittings and the thing which is sticking in the clean state. The thing by which a double-stick tape is sticking in applied pressure 30N/cm2.

9-22