9-38
* Notes:
1. Apply the load when attaching the parts. 20N to 30N
(2 to 3Kgf)/cm2
HDD Damper Ass’y
HDD Set Insert after removing the
Release Paper of the two-sided tape.
Fold the FPC from the board edge.
HDD Ass’y
Remove the Release Paper on
the back, close and attach it.
Attach it to HDD closely
not to loosen.
Make sure the product
with black sheet on the
yellow sponge.
Push and bend
CAUTION S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
S2
S2 Do not place the damper
over the plate of FPC. Do not place the damper
over the plate of heater.
Longer Direction
Sheet
HDD Thermal Plate
1~3
1~2
1~3
0~1
1~3 1~3
Attach the HDD Cushion (Yelllow)
Attach the
HDD Cushion
(Yelllow)
Attach the
HDD Cushion
(Black) Attach the HDD
Thermal Plate
HDD Cushion (Black)
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Prepare the metal plate bend.
To the level of attaching
closely in this range
When attaching HDD Cushion (Yellow) and HDD Cushion (Black),
set the bending part of the metal plate up.
Metal Plate
(15)
0–1
Do not bend it at a sharp
angle to put natural R.