VQT2S62
18
Preparation
∫Optical Image Stabilizer
The lens included in DMC-G10K has a stabilizer function.
•There is no [O.I.S.] switch on the 14 –42 mm/F3.5 –5.6 lens included in D M C-G 1 0K . Se t th e
[STABILIZER] settings in the [REC] Mode menu. (P116)
Attach the lens cap.Press the lens release button D while turning the lens as far as possible in the direction of the arrow to detach it.
•Always attach the body cap to the camera body so
that dirt or dust does not get inside.
•Attach the lens rear cap so that the lens contact
point does not get scratched.
Note
•Change lenses where there is not a lot of dirt or dust. Refer to P166 when dirt or dust gets on
the lens.
•When you turn the camera off or carry the camera, attach the lens cap to prot ect t he surf ace of
the lens.
•Be careful not to lose the lens cap, the lens rear cap and the body cap.
When using a lens with an [O.I.S.] switch, it is
possible to set to enable the Optical Image Stabilizer
by switching the [O.I.S.] switch on the lens to [ON].
•You can change the Optical Image Stabilizer Mode in
the [REC] Mode menu. (P116) It is set to [MODE1] at
the time of purchase.
•It is recommended to disable the Optical Image
Stabilizer when using a tripod. [ ] is displayed on
the screen at that time.
Example when a lens with the
[O.I.S.] switch is mounted.
Detaching a lens from the camera body
DMC-G10KPP-VQT2S62_eng.book 18 ページ ２０１０年４月２３日　金曜日　午後８時０分