Panasonic DMC-G10K operating instructions Taking Pictures using Burst Mode

Advanced (Recording pictures)

[REC] Mode:

Taking Pictures using Burst Mode

Pictures are taken continuously while the shutter button is pressed. Select the ones you really like from among the pictures you have taken.

Set the drive mode lever to [ ].

Focus on the subject and take a picture.

A When Burst Mode is set to high speed [H].

• Hold down the shutter button fully to activate the Burst Mode.

∫Changing the burst speed

A

1Select [BURST RATE] in the [REC] Mode menu. (P28)

2Press 3/4 to select the burst speed and then press [MENU/SET].

3Press [MENU/SET] to close the menu.

• You can also press the shutter button halfway to close the menu.

		[H]	[M]	[L]
		(High speed)	(Middle speed)	(Low speed)
Burst speed (pictures/second)		3.2	2.6	2
Live View during Burst Mode		None	Available	Available
¢1	With RAW files		4 to 7¢2
	Without RAW files	Depends on the remaining capacity of the card¢2

¢1 Number of recordable pictures

¢2 Pictures can be taken until the capacity of the card becomes full. However the burst speed will become slower halfway. The exact timing of this depends on the aspect ratio, the picture size, the setting for the quality and the type of card used.

•First burst speed has no relation with the transfer speed of the card.

•The burst speed values given above apply when the shutter speed is 1/60 or faster and when the flash is not activated.

•The Burst Mode speed may become slower depending on the following settings.

–[SENSITIVITY] (P79)/[PICTURE SIZE] (P114)/[QUALITY] (P115)/[FOCUS PRIORITY] (P126)/Focus Mode

•Refer to P115 for information about RAW files.

64 VQT2S62