Panasonic DMR-EZ49VEB manual Messages, On the Unit’s Display

Messages

On the Unit’s Display

H∑∑, F∑∑	≥ An error has occurred. The number following “H” or “F” depends on the status
(“∑” stands for a service number.)	of the unit. Check the items below and in the Troubleshooting Guide. If the
	service number still does not disappear after the check, reset the unit (> 82, To
	restore the unit if it freezes).
	≥ If the service numbers fail to clear, note the service numbers and contact a
	qualified service person.
DVD ∑	≥ The remote control and the main unit are using different codes. Change the
(“∑” stands for a number.)	code on the remote control. (> 82)
GUIDE	≥ GUIDE Plus+ data is being downloaded. (> 73)
HARD ERR§	≥ If there is no change after turning the unit on and off, consult the dealer where
	the unit was purchased.
NoCASSETTE§	≥ You have not inserted a video cassette for the recording. (> 7)
NoERAS	≥ You cannot delete items on this disc.
	≥ The disc may be damaged. Use a new disc.
NoREAD	≥ The disc is dirty or badly scratched. The unit cannot record, play, or edit. (> 7)
	≥ The disc may be incompatible or of poor quality. (> 15, 16)
	≥ You have used a lens cleaner and it has finished operation. Press [< OPEN/
	CLOSE] on the main unit to eject the disc. (> 6)
NoWRIT	≥ You cannot write to this disc.
	The disc may be damaged. Use a new disc.
FINAL	≥ When the screen asking if you want to finalise the disc appears, the message is
	displayed. (> 29)
PLEASE WAIT§	≥ Displayed when the unit is started. This is not a malfunction.
	≥ The unit is carrying out its recovery process. You cannot operate the unit while
	the message is displayed.
PROG FULL§	≥ There are already 16 timer recording programmes. Delete unnecessary timer
	recording programmes. (> 34)
PROTECT§	≥ You have inserted a video cassette without the accidental erasure prevention
	tab. Use a video cassette with an accidental erasure prevention tab. (> 7)
REMOVE	≥ The USB device is drawing too much power. Remove the USB device and turn
	the unit off.
SW-DL	≥ The unit is performing a software update. (> 73)
SP 35:50, LP 151h	≥ Available space on the disc.
“SP”, “LP” and the numbers are examples.	The example “SP 35:50” is displayed when less than 100 hours are available
	and the example “LP 151h” is displayed when over 100 hours are available.
	“SP” and “LP” are recording modes, “35:50” means “35 hours 50 minutes” and
	“151h” means “151 hours”.
UNSUPPORT§	≥ You have inserted a disc the unit cannot play or record onto. (> 15, 16)
	≥ You tried to operate with a non-compatible USB memory. (> 17)
UNFORMAT§	≥ You inserted an unformatted DVD-RAM, DVD-RW, +RW, an unused +R, +R DL
	or DVD-RW (DVD-Video format) that has been recorded on other equipment.
	Format the disc to use it.
	However all the recorded contents on the disc are deleted. (> 29)
EXT-L	≥ This unit is in EXT LINK standby. EXT LINK has been turned on and will stop
	operation on the unit until the recording has completed.
	Press [EXT LINK] to stop recording or cancel linked timer. (> 31)

§The message are alternately displayed.

80

VQT2J51