48
Special Features

Pause Feature

(For Analogue PBX Line/Long Distance Service Users)

We recommend you to insert “Pause” if a pause is required for dialling with a PBX or to access a long
distance service. See page 72 for selecting the pause timing.
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
H
Pause
Go Back
Ex. Line access number (PBX)
with the Handset/Base Unit
Phone number
OR
with the Handset
1Press then .
2Press and press to select “Pause”.
3Enter a phone number.
9
9
9
•Selecting “Pause” creates a pause. “P” is displayed.
This prevents misdialling when you redial or dial a stored number.
•Selecting “Pause” more than once increases the length of the pause between numbers.
9
9P1234567

Key Lock

You can lock the handset keypad. Only incoming calls are accepted while the key lock is ON .
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
To set the key lock
Press and hold until a beep sounds.
•“[X]” is displayed and all keypads are locked.
To cancel the key lock
Press and hold for about 2 seconds.
•“[X]” will disappear and the key lock will be cancelled.
•The key lock will also be cancelled when the power is OFF (p. 15).
•When the key lock is ON, emergency calls can not be made until the key lock is cancelled.
Base 1 [X]
10 New Calls
06.09 16:04
KX-TCD735ALM(E)-2(32~49) 2002.06.21 8:09 PM Page 48