Panasonic KX-TG5230C Troubleshooting, Refer to manual, Problem Cause & Remedy

If the Following Appears on Your Display...

Display message	Cause & Remedy
Wrong handset	for KX-TG6500C base unit, not the KX-TG5230C
Refer to manual	• This handset is not for this base unit. This handset is
	handsets for this base unit are KX-TGA520C and
	base unit included with this system. The accessory
	KX-TGA523C.

Troubleshooting

If the handset display shows error messages, see “If the Following Appears on Your Display...” (p. 71–73) for the Cause & Remedy.

Problem	Cause & Remedy
“No link to base.	• The handset has lost communication with the
Move closer to	base unit. Walk closer to the base unit, and
base and try	try again.
again.” is displayed and an	• Confirm that the base unit’s AC adaptor is
alarm tone sounds.	plugged in.
	• Raise the base unit antennas.
	• The handset’s registration may have been
	cancelled. Re-register the handset
	(p. 69, 70).
The handset and/or base unit	• Check the settings (p. 11–13).
does not work.	• Check whether the dialing mode setting is
	correct (p. 17).
	• Fully charge the battery (p. 12).
	• Clean the charge contacts and charge again
	(p. 13).
	• Check battery installation (p. 12).
	• Unplug the base unit’s AC adaptor to reset it.
	Plug in, and try again.
	• The handset has not been registered to the
	base unit. Register the handset (p. 70, steps
	5 and 6).
	• Re-install the battery (p. 12) and fully charge it.

Telephone System Answering System Useful Information

73