Panasonic KX-TG5230C operating instructions Recharge battery is

Troubleshooting

Problem Cause & Remedy

The handset and/or base unit does not announce the displayed caller’s name properly.

•Name pronunciation may vary.

•The handset and/or base unit will announce each letter of abbreviations, such as “Co.” and “Inc.”.

•Call Display service supports names of up to 15 letters. If the caller’s name has more than 15 letters, the name will not be announced correctly.

The handset display exits the	• Do not pause for over 60 seconds while
Caller List or phone book.	searching.
“Recharge battery” is	• Fully charge the battery (p. 12).
displayed, “3” flashes,
or the handset beeps
intermittently.

“Charge for 6 HRS” and “4” are displayed and the handset does not work.

•The battery has been discharged. Fully charge the battery (p. 13).

You charged the battery fully, but “Recharge battery” is still displayed and/or “3” continues to flash, or “Charge for 6 HRS” and “4” are displayed.

•Clean the charge contacts and charge again (p. 13).

•The battery may need to be replaced. If you install a new battery, fully charge it (p. 12, 13).

The CHARGE indicator does	• This is normal.
not go out after the battery has
been charged.
The Ringer/Message Alert	• The Message Alert is turned on and new
indicator flashes slowly when	messages in your voice mailbox have been
the handset is not ringing or in	recorded. Turn the Message Alert off (p. 22)
use.	or listen to the new messages (p. 54).
You cannot have a	• Make sure the optional headset is connected
conversation using the	properly (p. 63).
headset.	• If “SP-phone” is displayed on the handset,
	press [C] to switch to the headset.

76