Panasonic KX-TG5230C Voice Mail Service, Setting Voice Mail VM Tone Detection Handset, Off

Voice Mail Service

To erase a stored voice mail access number

Repeat steps 1 to 4 on page 52, then press and hold the soft key ( CLEAR ) until all of the digits are erased. Press the soft key ( SAVE ), then press

[OFF].

Setting Voice Mail (VM) Tone Detection Handset

Your telephone company sends special signals (Voice mail tones) to the unit. Press [C], [s] or [SP-PHONE]to listen to the dial tone. If you hear a series of dial tones followed by a continuous dial tone, this indicates that a new message was recorded. Voice Mail detection is preset at the factory to OFF. Minutes after you hang up or after the phone stops ringing, your unit will check the phone line to see if a message has been recorded. If a new message was recorded at your telephone company, “Voice Mail” will be displayed on the handset, the Ringer/Message Alert indicator on the handset will flash slowly if Message Alert is turned on (p. 22), and the VM indicator will flash on the base unit.

Leave this feature off when:

—you do not subscribe to a voice mail service,

—your telephone company does not send a series of tones followed by a continuous tone to indicate that you have new voice mail, or

—your phone is connected to a business or office telephone system (PBX).

See below to turn this setting on.

If you are not sure which setting is required, consult your local telephone company or contact the Panasonic Customer Call Centre.

1	Press [MENU].
2	Scroll to “Initial setting” by pressing
				Initial setting
	[d] or [B], then press the soft key (		).
		SELECT

3Press the soft key ( SELECT ) at “Voice Mail”. Voice Mail

4	Scroll to “VM tone detect” by pressing
				VM	tone	detect
	[d] or [B], then press the soft key (		).
		SELECT
5	Select “On” or “Off” by pressing [d] or [B].
				VM	tone	detect

:Off

6Press the soft key ( SAVE ), then press [OFF].

Telephone System Advanced Operation

53