When to Call a Service Engineer
If an “F” Appears In The Display
Your Panasonic Combi Oven is equipped with a Self Diagnostic Failure Code System; this means the oven monitors its own operation and will show a failure code in the display window in the unlikely event of a malfunction.
If a Failure Code appears in the display window (it will appear as an “F” then a two digit number) follow these steps:
1.Close the door and switch off at socket. Ensure all air vents are clear.
2.Leave 1 minute and then reconnect the oven at the mains.
3.Open the door and place food or a jug of water in the cavity, close the door.
4.Try the same function that had been in operation prior to the appearance of the Failure Code in the display window.
If the Failure Code appears again, then contact the dealer from which you purchased the oven, the manufacturer or a known Approved Service Agent. See contacting a Service Engineer.
If a “U” Appears In The Display
A fault with the SD Memory Card will also show as a Failure Code in the display window (it will appear as a “U” then a two digit number). Follow the steps in the following chart:
CODE | PROBREM | WHAT TO DO | ||
|
|
| ||
U16 | SD Memory Card is | Take out the SD Memory Card & remove the | ||
| locked. | Lock. (see below). Insert the SD Memory | ||
|
| Card again. |
|
|
|
|
|
| |
|
|
|
|
|
|
| Lock is removed | LOCK | |
|
| when this part is |
|
|
|
| pushed upwards. |
|
|
|
|
| Recipe | |
|
|
| Card | |
U17 | There is no | An SD Memory Card confirms that it is |
| programme data | attached to this oven. Please check whether |
| from this oven on | there is programme data from the oven on |
| the SD Memory | the SD Memory Card in your personal |
| Card. | computer. |
| Programme data | (See page P.75) |
| on the SD Memory | When programme data is deleted, please |
| Card is damaged. | contact Service Engineer. |
U19 | SD Memory Card is | Remove the SD Card Cover and insert an |
| not inserted. | SD Memory Card. |
70
