Panasonic WJ-HD200 manual 8Disk Menu

●DISK MENU

8Disk Menu

The menu appears if the hard disk error is found during power-up.

The buzzer beeps every 5 seconds, and ERROR indi- cator turns off.

Press buttons other than [STOP] to mute buzzer beep.

Hard disk status and required operation are shown in the table.

DISK MENU

NO.1:117.95GB

NO.2:117.95GB

REMOVE LINK→ SET→ HDD FORMAT → SET→

RESTART → SET→

Hard Disk Status

Operation

Abbreviation	Status	Required	Note
Capacity	Normal status	–
ERR	Writing error	Format, remove link ,or replace HDD	Abbreviation SYS appears in SYSTEM
		if erred even after formatting.	LOG when indicating a writing error.
	LOST or * status was left for	Same as above.
	five minutes.
*	Awaiting format	Format	Replaced HDD has been not format-
			ted yet.
	HDD error	Replace HDD if erred even after	Replaced HDD malfunctions.
		formatting.
	HDD logically removed	Remove HDD to add a new one,	Appears only when manually opening
		or reconnect.	DISK MENU.
LOST	HDD physically removed	Remove link, or add a new HDD.
ADD	HDD added, and awaiting	Format
	format
–	Previous time and this time,		REMOVE LINK command has been
	HDD logically removed		previously carried out .

You can implement necessary operation from among them.

REMOVE LINK: Removes logically the HDD link.

HDD FORMAT: Formats the HDD.

RESTART: Closes the menu, and returns to normal operation.

The menu can also be displayed manually when you need to format HDD, or to remove the logical link.

1.Turn off the power of the recorder once, and turn it on again.

The multi-screen monitor displays a message “SYSTEM CHECK DONE! TO OPEN DISK MENU, PUSH STOP KEY”.

2.Press the [STOP] button. The DISK MENU opens.

3.Select any of REMOVE LINK, HDD FORMAT, or RESTART.

Auto-remove

When no button is pressed for 5 minutes after opening the DISK MENU, The recorder will logically remove the disk that meets any conditions below.

•An HDD has been categorized in “ * ”, “LOST”, or “ERR”.

•Restart was repeated 3 times due to writing error.

88