Panasonic WJ-HD200 Alteration Detection Setup, Disk End Mode Setup, Disk End Buzzer Disk END Buzz

•Simultaneous playback will pause prior to a time space depending on the recording rate if recording nears to the playback point.

0.1FPS: 20 minutes maximum 1 FPS: 2 minutes maximum

7.5FPS: 15 seconds maximum 15 FPS: 7 seconds maximum

•Actual recording rate even preset to 30 or 15 FPS may be lessened to 7.5 FPS at worst, while such busy multi task as playback, remote-access play- back, remote-access live image, FTP access, multi split display, video motion detection are carried out

at	a time. The status display will indicate as
“*→	PLAY” while playing back the images recorded

with a changed rate from the preset.

●Alteration Detection Setup

ALTER DETECT

You can enable or disable the recorder to add alteration- detection signals in the JPEG data supplied to the network. The default is OFF.

1.Move the cursor to ALT DET.

2.Select ON or OFF with the JogDial and press the JogDial.

ON: Detects alterations.

OFF: Does not detect.

Note: When set to ON, the data transmission rate on the network will slow down.

●Disk End Mode Setup

DISK END MODE

The menu offers the following options at the point where the available recording space on the disk is used up: [STOP], [CONTINUE].

SYSTEM SETUP	(1 OF 2)
PASSWORD LOCK	OFF
ALL→	*****
OPERATION→	*****
KEYLOCK BUZZ	OFF
SKIP ALM-RECALL	5PAGE
SIMUL REC&PLAY	ON
ALTER DETECT	OFF
DISK END MODE	CONTINUE
DISK END BUZZ	ON

1.Move the cursor to DISK END MODE with the [D] or [C] button.

2.Select the desired mode with the JogDial, and press the JogDial.

The default is CONTINUE.

STOP: Stops recording until a new mode other than [STOP] is selected.

CONTINUE: Old data is automatically overwritten from the disk start.

Note: Remaining capacity will be displayed on the monitor by turning the JogDial counter-clockwise in recording mode when STOP is selected.

●Disk End Buzzer DISK END BUZZ

The buzzer can be set up to beep at the point where the disk is full (remaining space 0 %). The setting is available only when STOP is set for DISK END MODE.

1.	Move the cursor to DISK END BUZZER with the [D] or
	[C] button.
2.	Rotate the JogDial to select the desired parameter.
	The default is ON.
	ON: Enables the buzzer beep at the disk end (remain-
	ing space 0 %).
	OFF: Disables the buzzer beep.

[STOP]

[CONTINUE]

[Default]

DISK STARTDISK END

					Stop
					REC
			Waiting for a new entry
	Restart
	REC
DISK START				DISK END
DISK START				DISK END
		Overwritten automatically

● Play Priority Setup PLAY PRIORITY

This setting places priority on a specific access point for playing back the image data when access collisions take place.

1.	Move the cursor to PLAY PRIORITY.
2.	Select an access point with the JogDial and press the
	JogDial.
	LOCAL: Places priority on the front panel operations.
	NET PLAY: Places priority on the network access.

DISK START DISK END

FTP GET: Places priority on the access to the FTP.

NONE: The latest operation has priority than others.

33