Panasonic WJ-HD200 manual Communication Setup COMMUNICATION SETUP, Serial Setup SERIAL SETUP

*

CAM1

Notes:

•VMD should be used with an ordinary camera input to the unit. Select [OFF] to avoid useless VMD when a video multiplexer or combination camera supplies the input to the unit.

•Set the ALARM SUSPEND to ON when VMD is unnecessarily activated during the VMD setup.

4.Set the upper-left end of the detection area. Move the asterisk to the right or left with the JogDial, and up or down by pressing the [D] or [C] button.

REW/FF
/
STEP
/
PUSH • PAUSE	SET
/	/

5.Press the JogDial to enter the upper-left end of the detection area. The asterisk position is highlighted.

6.Set the bottom-right end of the detection area similar to steps 3 and 4 above.

7.Press the JogDial. The area is highlighted.

Up to 4 areas can be selected. These may partially overlap. Repeat steps 3 to 6 to select more areas. To deselect an area, move the cursor to the upper-left end of the area, and press the JogDial.

q e

w

r

■Communication Setup

COMMUNICATION SETUP

Communication parameters are set to match those of the connected devices and the system configuration. The serial port setup and network setup are made.

COMMUNICATION SETUP

SERIAL SETUPO

NETWORK SETUPO

■Serial Setup SERIAL SETUP

The SERIAL SETUP menu appears when it is selected in the COMMUNICATION SETUP menu.

SERIAL SETUP

PROTOCOL		PS•DATA
BAUD RATE		9600
DATA BIT		8
PARITY CHECK		NONE
STOP BIT		1
WAIT TIME		OFF
CTL-UNIT	ADDR	1
SYS-UNIT	ADDR	1
ALARM DATA		1S
CAM NO.SETUPO

Note: Parameters marked with * in the following pages are default settings applied to VCR.

●Protocol PROTOCOL

1.Move the cursor to PROTOCOL with the [D] or [C] but- ton.

2.Select a suitable protocol with the JogDial, and press the JogDial.

The default is PS• DATA.

PS• DATA: Select when the communication chain uses the PS• DATA protocol.

This selection enables the DATA terminal on the rear panel for communication.

VCR: Select when other than PS• DATA is used.

This selection enables the RS-232C terminal on the rear panel for communication.

Note: Parallel use of the DATA and RS-232C terminals is not possible.

36