Panasonic WJ-HD200 manual Connection with the Camera Site, Connection with the Monitors

■Connection with the Camera Site

●System Camera Connection

Connect the system cameras directly to the recorder.

IN	8	7	6
OUT	8	7	6

●Data-multiplex Camera Connection

Connect the combination cameras and the receiver via the multiplex unit with the recorder.

Combination Cameras

Pan/Tilt Table

Receiver

POWER	ALARM	Data Multiplex
ALARM	SUSPEND	Unit
OFF
ON

Data Multiplex Unit WJ-MP204

4	3	2	1
			SPOT
			OUT	A
4	3	2	1
O			MULTI	RS-23
			SCREEN OUT

■Connection with the Monitors

Connect the spot and multi-screen monitors.

Disk Recorder

WJ-HD200

SPOT

OUT

MULTI

SCREEN OUT

Spot Monitor Multiscreen Monitor

■ALARM/REMOTE Connection

A 25-pin connector is used to accept and supply control signals.

		13				1
		25	ALARM/REMOTE			14
Pin	Designation			Pin		Designation
#				#
1	Alarm Reset In			14	Time Adjust Out
2	Alarm 1 In			15	Alarm 5 In
3	Alarm 2	In		16	Alarm 6 In
4	Alarm Recovery 1* Out			17	Alarm 7 In
5	Alarm Recovery 2 Out			18	Alarm 8 In
6	Alarm 1	Out		19	Signal GND
7	Alarm 2* Out			20	Signal GND
8	Disk End Out			21	Play Status Out
9	Warning Out			22	EXT REC MODE In
10	Alarm 3	In		23	No Connection
11	Alarm 4	In		24	Sequence In
12	REC Status Out			25	Sequence Out
13	Time Adjust In

16