●Post-alarm Recording POST ALM REC
This setting specifies the duration of alarm recording after an alarm input. Functions active during alarm recording are buzzer beeping, ALARM LED indication, "ALARM" status display, and the ALARM OUT signal.
1.Move the cursor to POST ALARM REC with the [D] or [C] button.
2.Select the desired duration with the JogDial. The default value is 10 seconds.
The unit will revert to the previous status when the time has elapsed.
Available Time (Second): 5, 10, 20, 30
Available Time (Minute): 1, 1.5, 2, 3, 6
Continue: Recording continues until the [REC STOP] button is pressed, or RESET IN signal is supplied to the rear panel.
Manual:Recording continues while the alarm input is active, or at least for 10 seconds if the input early turns inactive.
●Dynamic Recording DYNAMIC REC
This setting specifies recording pattern on the disk when one or more alarm operate.
1.Move the cursor to DYNAMIC REC with the [D] or [C] button.
2.Select the parameter with the JogDial, and press the Jogdial.
The default is OFF.
OFF: All channels are evenly recorded.
●Trigger Action Setup TRIGGER ACTION SETUP
This setting specifies two roles of the alarm recording and alarm control functions (Refer to page 44) in the
TRIGGER ACTION SETUP
CAM | MODE |
1 | OFF |
2 | OFF |
3 | OFF |
4 | REC&ALM |
5 | REC |
6 | OFF |
7 | OFF |
8 | OFF |
1.Move the cursor to TRIGGER ACTION SETUPO, and press the JogDial.
The TRIGGER ACTION SETUP menu opens.
2.Move the cursor to the channel.
3.Select the parameter with the JogDial, and press the Jogdial.
The default is REC&ALM.
OFF: Disables alarm recording or warning.
REC&ALM: Enables both alarm recording and warning.
REC: Enables alarm recording, but disables warning.
4.Repeat steps 2 and 3 until all channels are set.
5.Press the [SETUP/ESC] button to return to the PROG “1” NO. “1” SETUP menu.
●Camera Recording Setup CAM REC SETUP
This setting is provided for the purpose of disk space sav- ing. Setting allows each camera channel to be enrolled in all recording modes or exclusively in alarm recording.
CAM REC SETUP
CAMMODE
1REC
2REC
3REC
4
5REC
6
7REC
8REC
1.Move the cursor to CAM REC SETUP, and press the [SET] button. The CAM REC SETUP menu opens.
2.Move the cursor to the camera channel with the [D] or [C] button.
3.Select the parameter with the JogDial, and press the JogDial.
The default is REC.
REC: The channel is recorded in alarm recording, timer recording and manual recording mode.
4.Repeat steps 2 and 3 until all channels are set.
5.Press the [SETUP/ESC] button to return to the PROG “1” NO. “1” SETUP menu.
27