Panasonic WJ-HD616K, WJ-HD716K manual Operation Mode, Rec. cam, Preset, Output terminal

Configure the event action at a VMD occurrence [VMD]

Select the [VMD] tab on the "Event" page. (☞ Page 60)

The settings relating to event actions to be taken at a VMD (☞ Operating Instructions (PDF)) occurrence can be configured on this tab.

[Operation Mode]

Select the settings for the operation mode. Refer to the operating instructions (PDF) for further information about the operation mode.

ADM (Activity Detection Mode): Performs only recording and writing an event log at an event occur- rence. Other event actions will not be performed.

ALM (Alarm Mode): Performs every event action according to the settings.

Off: Performs only writing an event log. Other event actions will not be performed.

Configure the following settings for each camera channel (1 to 16).

[Rec. cam.]

Select a camera channel (1 to 16) used for recording. When "Off" is selected, recording will not be performed.

[Preset]

Select a preset position (1 to 256) to which the camera will move at a VMD detection.

When the preset positions of two or more cameras have been selected on the advanced setup page, "∗∗∗" is dis- played and it is impossible to select the values.

[Output terminal]

Select a terminal (TRM1 to TRM16) to output the alarm sig- nal.

75