Configure the event action at a video loss occurrence [Video loss]
Select the [Video loss] tab on the "Event" page. (☞ Page 60)
The settings relating to event actions to be taken at a video loss (☞ Operating Instructions (PDF)) occurrence can be configured on this tab.
[Operation mode]
Select the settings for the operation mode.
Refer to the operating instructions (PDF) for further informa- tion about the operation mode.
ADM (Activity Detection Mode): Performs recording, writes the event log, and moves the cameras to pre- set positions at an event occurrence. Other event actions will not be performed.
ALM (Alarm Mode): Performs every event action according to the settings.
OFF: Performs only writing an event log. Other event actions will not be performed.
Configure the following settings for each camera channel (1 to 16).
[Rec. cam.]
Select a camera channel (1 to 16) used for recording. When "Off" is selected, recording will not be performed.
[Preset]
Select a preset position (1 to 256) to which the camera will move at a video loss occurrence.
When the preset positions of two or more cameras have been selected on the advanced setup page, "∗∗∗" is dis- played and it is impossible to select the values.
74