Panasonic WJ-HD716K manual Precautions for Installation, This product is designed for indoor use

Precautions for Installation

This product is designed for indoor use.

Avoid the following locations for installation.

•Locations exposed to direct sunlight

•Places subject to having strong vibration or impact

•Near magnetic field sources such as a television or speakers

•Place where condensation forms easily, where tempera- ture changes greatly, humid places

•Steamy and oily places such as kitchens

•Places which are not level

•Places subject to dust

•Places subject to water splash or spray

Do not install this product in locations where the prod- uct or the cables can be destroyed or damaged by persons with malicious intent.

Place this product horizontally on a level surface.

Do not place this product in an upright position. When stacking multiple recorders, clear a space of more than 5 cm {1-31/32"} from both sides, the top, the bottom and the rear of them.

More than 5 cm {1-31/32"}

More than

5 cm {1-31/32"}

More than

5 cm {1-31/32"}

Heat dissipation

Refer to the following to prevent fire and malfunction of this product.

•Do not block the ventilation openings in the cover to pre- vent this product from overheating. Maintain this product periodically to prevent dust from blocking openings.

•A lifetime of cooling fans is limited by use. It is recom- mended to replace them after approx. 30 000 hours of operation. Contact your dealer for replacement of the cooling fans.

•Clear a space of more than 5 cm from both sides, the top and the rear of this product. Do not block the venti- lation openings on the front cover since this product is designed to cool the hard disk drives by inhaling air from the front.

Avoid placing the unit near noise sources

If the cables are placed near noise sources such as fluores- cent lamps, noises may be produced. In this case, rewire avoiding the noise sources, or move this product to a place far from the source.

Power source

A grounding connection must be made before connecting the power plug of this product to the main power supply. When disconnecting the grounding wire, make sure that the power plug of this product is disconnected from the main power supply.

How to mount the power cord

Be sure to connect the power cord via any of the following breaking devices:

•Connect the power cord via a power supply control unit.

•Install the product near a power outlet, and connect the power cord via the power plug.

•Connect the power cord to the breaker with contact gap of 3.0 mm or more of a distribution board. The breaker shall be able to shut down all the poles of the main power supply except the ground protective conductor.

14