Panasonic WJ-HD716K Protocol, Default Panasonic Baud rate, Control camera ch, •Term, •Back button

Configure the settings relating to RS485 [RS485 setup]

Select the [RS485 setup] tab on the "Communication" page. (☞ Page 60) The settings for RS485 can be configured on this tab.

[Protocol]

Select the protocol used for RS485 communication. Panasonic/Pelco-D

Default: Panasonic

[Baud rate]

Select a communication speed for data transmission with a connected device from the following:

2 400/4 800/9 600/19 200/38 400 (bps) Default: 19 200

[Control camera ch]

Allocate the RS485 port 1 and port 2 to camera channels. When the [Setup] button is selected, the following page will be displayed.

•[TERM]

Select a port to be controlled from the following for each camera channel.

PORT1: Controls from the RS485 port 1.

PORT2: Controls from the RS485 port 2.

•[Back] button

Closes the setup page and returns to the [RS485 setup] tab.

[Data bit]

The data length for communication will be displayed. 7/8 (bit)

Default: 8

[Parity]

Methods of error check for a transmission at communication will be displayed.

NONE: No parity check

EVEN: Even parity

ODD: Odd parity Default: NONE

[Stop bit]

Stop bit types will be displayed. 1/2 (bit)

Default: 1

94