4. DSL Router Configuration Examples
Downstream Router Configuration Example
Customer Premises (CP)
Systems
Core
Router
Console
155.1.3.1
Port Connection
DSL |
| Ethernet |
WAN |
|
|
dsl1 | DSL | eth1 |
155.1.3.2 | Router | 120.26.7.5 |
| 120.26.7.1 |
| 120.26.7.2 |
| 120.26.7.3 |
Hub | 120.26.7.100 |
Router |
Systems
130.26.7.1 
130.26.7.2 
Hub 
130.26.7.3 
In this downstream router example:
There are clients statically configured and connected to the DSL router.
There are also clients connected behind a downstream router.
The DSL interface (dsl1) is numbered.
The next hop router for downstream forwarding from the core router to networks 120.26.7.0 and 130.26.7.0 is the DSL router’s DSL interface (dsl1).
The commands and syntax for this example are:
ip routing enable
ifn address eth1 120.26.7.5 255.255.255.0 ifn address dsl1 155.1.3.2 255.255.255.0 ip route create upstream eth1 155.1.3.1
ip route create 130.26.7.0 255.255.255.0 120.26.7.100
NOTES:
—The ip routing enable command is only required when using firmware version 4.2.5 or higher.
—FUNI/MPOA (1483 routed) link encapsulation can be used with this configuration and the DSL card Models 8304, 8314, 8344, and 8374. Link encapsulation is configured on the DSL port. This link encapsulation must match the core network encapsulation type. The ip route create upstream command is not necessary when using FUNI/MPOA link encapsulation.
November 2003 |
