A. Command Line Interface

Traps Command

Table A-15. Traps Command

trap {enable disable} name of trap

Minimum Access Level: Administrator

Command Mode: Config

Enables or disables the sending of traps. The default is disable. name of trap:

authen fail – An incorrect login was entered at the console.

ccn – A configuration change has occurred (configuration change notification). devfail – The router has detected an internal failure.

link up – The Ethernet link is up and operational. link down – The Ethernet link is down. selftest – A failure occurred during a restart. test start – A test has started on the interface. test stop – A test has completed on the interface. warmstart Power-on reset has taken place.

For additional information, refer to Appendix C, Traps and MIBs.

Clearing Statistics Command

Performance statistics can be cleared using the CLI, resetting the statistical counts to zero.

Table A-16. Clearing Statistics Command

clear statistics [ eth1 dsl1 ip bridge pppoe tftp ]

Minimum Access Level: Administrator

Command Mode: Standard

Clears the specified set of statistics. If no set of statistics is entered, ALL statistics for the router are cleared.

Example: clear statistics eth1

eth1 Ethernet interface statistics.

dsl1 DSL interface statistics.

ip IP processing statistics.

bridge Bridge statistics.

pppoe – PPPoE statistics.

tftp – TFTP statistics.

6300-A2-GB20-10

November 2003

A-23

Page 97
Image 97
Paradyne 6301, 6341, 6342, 6371, 6351, 6302 manual Table A-15. Traps Command, Table A-16. Clearing Statistics Command