Configuration Using Console Interface

command prompt. To enter CLI management interface, type in enable command. Please see below figure for CLI command interface.

3-4 Command Levels

The table below lists the command levels. For Command Set Lists, please refer to Appendix C.

Modes

Access Method

Prompt

Exit Method

About This Mode

User EXEC

Begin a session

switch>

Enter logout or

The user commands available at the

 

with your switch.

 

quit.

user level are a subset of those

 

 

 

 

available at the privileged level.

 

 

 

 

Use this mode to

 

 

 

 

• Perform basic tests.

 

 

 

 

• Display system information.

Privileged

Enter the enable

switch#

Enter disable to

The privileged command is the

EXEC

command while

 

exit.

advanced mode.

 

in User EXEC

 

 

Use this mode to

 

mode.

 

 

• Display advanced function status.

 

 

 

 

• Save configuration

Global

Enter the

switch

To exit to

Use this mode to configure those

Configuration

configure

(config)#

privileged EXEC

parameters that are going to be

 

command while

 

mode, enter exit

applied to your switch.

 

in privileged

 

or end.

 

 

EXEC mode.

 

 

 

VLAN

Enter the vlan

switch

To exit to user

Use this mode to configure

database

database

(vlan)#

EXEC mode,

VLAN-specific parameters.

 

command while

 

enter exit.

 

 

in privileged

 

 

 

 

EXEC mode.

 

 

 

Interface

Enter the

switch

To exit to global

Use this mode to configure

configuration

interface of fast

(config-if)#

configuration

parameters for the switch and

 

Ethernet

 

mode, enter exit.

Ethernet ports.

 

command (with

 

To exit to

 

 

a specific

 

privileged EXEC

 

 

interface) while

 

mode, enter exit

 

 

in global

 

or end.

 

 

configuration

 

 

 

 

mode.

 

 

 

3-2

Page 16
Image 16
Husky HME-421E, HME-423E Command Levels, Modes Access Method Prompt Exit Method About This Mode, Configure, Database