Husky HME-421E, HME-423E user manual Spanning Tree Commands Set

			Command Set Lists
hybrid-link untag			or
[UntaggedVID]			switch(vlan)#vlan 8021q trunk 3
tag			hybrid-link untag 5 tag 6-8
[TaggedVID List]
show vlan [GroupID]	V	Show VLAN information	switch(vlan)#show vlan 23
or
show vlan
no vlan group	V	Delete port base group ID	switch(vlan)#no vlan group 2
[GroupID]

C-6 Spanning Tree Commands Set

Commands	Level	Description	Example
spanning-tree enable	G	Enable spanning tree	switch(config)#spanning-tree enable
spanning-tree priority	G	Configure spanning tree	switch(config)#spanning-tree priority
[0~61440]		priority parameter	32768
spanning-tree max-age	G	Use the spanning-tree	switch(config)#spanning-tree max-age
[seconds]		max-age global	15
		configuration command to
		change the interval
		between messages the
		spanning tree receives
		from the root switch. If a
		switch does not receive a
		bridge protocol data unit
		(BPDU) message from
		the root switch within this
		interval, it recomputes the
		Spanning Tree Protocol
		(STP) topology.
spanning-tree hello-time	G	Use the spanning-tree	switch(config)#spanning-tree
[seconds]		hello-time global	hello-time 3
		configuration command to
		specify the interval
		between hello bridge
		protocol data units
		(BPDUs).
spanning-tree forward-time	G	Use the spanning-tree	switch(config)#spanning-tree
[seconds]		forward-time global	forward-time 20
		configuration command to
		set the forwarding-time for
		the specified
		spanning-tree instances.
		The forwarding time
		determines how long
		each of the listening and
		learning states last before
		the port begins
		forwarding.
stp-path-cost	I	Use the spanning-tree	switch(config)#interface fastEthernet 2
[1~200000000]		cost interface	switch(config-if)#stp-path-cost 20
		configuration command to

C-6