Husky HME-423E, HME-421E user manual switchconfig#interface fastEthernet

			Command Set Lists
duplex	I	Use the duplex	switch(config)#interface fastEthernet 2
[full half]		configuration command to	switch(config-if)#duplex full
		specify the duplex mode
		of operation for Fast
		Ethernet.
speed	I	Use the speed	switch(config)#interface fastEthernet 2
[101001000auto]		configuration command to	switch(config-if)#speed 100
		specify the speed mode
		of operation for Fast
		Ethernet. The speed can’t
		be set to 1000Mbps if the
		port isn’t a giga port.
no flowcontrol	I	Disable flow control of	switch(config-if)#no flowcontrol
		interface
security enable	I	Enable security of	switch(config)#interface fastEthernet 2
		interface	switch(config-if)#security enable
no security	I	Disable security of	switch(config)#interface fastEthernet 2
		interface	switch(config-if)#no security
bandwidth type all	I	Set interface ingress limit	switch(config)#interface fastEthernet 2
		frame type to “accept all	switch(config-if)#bandwidth type all
		frame”
bandwidth type	I	Set interface ingress limit	switch(config)#interface fastEthernet 2
broadcast-multicast-flooded-		frame type to “accept	switch(config-if)#bandwidth type
unicast		broadcast, multicast, and	broadcast-multicast-flooded-unicast
		flooded unicast frame”
bandwidth type	I	Set interface ingress limit	switch(config)#interface fastEthernet 2
broadcast-multicast		frame type to “accept	switch(config-if)#bandwidth type
		broadcast and multicast	broadcast-multicast
		frame”
bandwidth type	I	Set interface ingress limit	switch(config)#interface fastEthernet 2
broadcast-only		frame type to “only accept	switch(config-if)#bandwidth type
		broadcast frame”	broadcast-only
bandwidth in	I	Set interface input	switch(config)#interface fastEthernet 2
[Value]		bandwidth. Rate Range is	switch(config-if)#bandwidth in 100
		from 100 kbps to 102400
		kbps or to 256000 kbps
		for giga ports, and zero
		means no limit.
bandwidth out		Set interface output	switch(config)#interface fastEthernet 2
[Value]		bandwidth. Rate Range is	switch(config-if)#bandwidth out 100
		from 100 kbps to 102400
		kbps or to 256000 kbps
		for giga ports, and zero
		means no limit.
show bandwidth	I	Show interfaces	switch(config)#interface fastEthernet 2
		bandwidth control	switch(config-if)#show bandwidth
state	I	Use the state interface	switch(config)#interface fastEthernet 2
[Enable Disable]		configuration command to	switch(config-if)#state Disable
		specify the state mode of
		operation for Ethernet
		ports. Use the disable
		form of this command to
		disable the port.

C-3