Paradyne 8510 DSL Bridge Options 2, Client Vlan Client, Parameters a, ARP Entry Add ARP Entry B

8310 MVL and 8510 DSL Card Configuration

Table 5-4. Bridge Options (2 of 2)

Client VLAN (Client) A-E-D

Gives the user the ability to configure static clients on VLANs. As there are up to 32 clients per port, multiple screens are required to completely configure the port.

For a list of VLAN IDs, press Ctrl-v.

DSL Port # ± Enter the DSL port number (Default = 1).

Number of clients ± Enter the number of clients to configure (0 ± 32) (Default = none).

User ± Enter the input number of the client (0 ± 32) (Default = 0).

IP Address ± Enter the client IP address in nnn.nnn.nnn.nnn format (Default = none). There must be an entry in this field. Typically, all IP addresses in the same VLAN would be on the same subnet.

NHR ± Enter the IP address of the default next-hop router in nnn.nnn.nnn.nnn format (Default = none).

VLAN ± VLAN ID between 2 and 4094. (This field is read-only.)

Type ± S = Static or D = Dynamic. (This field is read-only.)

ARP (Parameters and Add ARP Entry) A-E-E (A and B)

Select:

Parameters (A)

Gives the user the ability to configure general Address Resolution Protocol (ARP) cache parameters.

Complete Entry Timeout (minutes) ± Length of time that a complete entry remains in the ARP Table before removal. A complete entry is one for which there is a MAC address and a node has responded to the ARP request. Range = 1 to 200,000 minutes. (Default = 20)

Incomplete Entry Timeout (minutes) ± Length of time in minutes that an incomplete entry remains in the ARP table before being removed. (An incomplete entry is an entry without a MAC address.) This is also the amount of time that a packet will remain in the system while waiting for address resolution. Range = 1 to 255 minutes. (Default = 3)

NOTE: If you have made changes to this screen, you must do a card reset.

ARP Entry (Add ARP Entry) (B)

Gives the user the ability to add entries into the ARP cache.

Item ± Enter 0 (zero) to add a new record.

IP Address ± nnn.nnn.nnn.nnn format.

MAC Address ± xx-xx-xx-xx-xx-xx format.

VLAN ± Enter a VLAN ID between two and 4094 (Default = Null). There must be an entry made in this field.

Trailer ± Yes/No (Default = No).

Perm ± Yes/No (Default = No). If you select yes for Perm and no to proxy, the ARP entry will be saved in NVRAM (up to 32 entries). These are loaded when the card reboots.

NOTE: For the Add ARP Entry screen, all other information entered is not stored in the nonvolatile memory and will be lost when you reset the card.

8000-A2-GB26-00 May 1998 5-11