Paradyne 8510 DSL, 8310 MVL manual Additional Setup Instructions

Initial Setup Instructions

3.Do one of the following at the (nnn.nnn.nnn.nnn): prompt:

ÐTo accept the subnet mask, press Return or,

ÐTo enter a different subnet mask, enter a new subnet mask and press Return.

The system highlights the OK to restart?: prompt.

4.Type y at the yes/no: prompt to restart the card or n to decline the restart.

If you type y, the card restarts. The system displays the Hotwire Chassis Main Menu.

NOTE:

At this point, the MCC card can accept a Telnet session for remote configuration.

If an MCC powers up with no router ID (for new cards or after a clear NVRAM command has been executed), the MCC will perform a BOOTP out the Ethernet interface to acquire an IP address and subnet mask. This IP address and subnet mask is kept in non-volatile storage if you want to enter or override this information on either the Who Am I screen or the MCC Ethernet IP Address screen.

Additional Setup Instructions

This section describes additional setup instructions you should perform. On the Chassis Information screen, you can enter pertinent chassis information, such as the chassis name, name of the person responsible for the system, and the physical location of the chassis.

8000-A2-GB26-00 May 1998 3-3