8310 MVL and 8510 DSL Card Configuration
"Procedure
To view DSL card information and configure Maximum Transmission Unit (MTU) settings or restart, stop, or monitor an interface:
1.Follow this menu sequence: Configuration → Interfaces
2.The Interfaces menu appears. Enter the desired value on each selected screen and field as shown in Table
Table 5-3. Interfaces Options
General (General Interfaces) | |
|
|
Gives the user the ability to view basic card interface information about a given interface.
Interface Name ± 3 characters. e1a = Ethernet port; s1c, s1d, s1e and s1f = DSL or
MVL interface.
Type ± Static/Dynamic. Interface type.
Protocol ± HDLC or Ethernet. Interface protocol.
Port List ± Ports available on the card.
MTU (max) ± 64±1600 bytes (Default = 1536).
NOTE: The above MTU values are the only values you may enter. Make certain that if you change from the default value, the new numbers are appropriate to your network. Do a card reset or reset the Ethernet interface.
Control (Control Interfaces) | |
|
|
Gives the user the ability to start, stop, and monitor (up, down, or testing) the current state of an interface.
NOTE: Stopping the interface disables all of the traffic on that port, including diagnostics. If you want to only disable customer traffic, instead disable all VLANs on that port.
There are no
DSL Configuration Users Screens
Use the system information submenu of the Users screens to configure login accounts for Telnet sessions directly to the DSL cards.
This menu item is not currently supported on this card.
May 1998 |
