Paradyne 8310 MVL, 8510 DSL 5-10, General, A-E-A, Card VLAN Card, A-E-B, Port VLAN Port, A-E-C

8310 MVL and 8510 DSL Card Configuration

Table 5-4. Bridge Options (1 of 2)

General A-E-A

Gives the user the ability to configure bridge aging timeouts for MAC entries on the bridge and general bridge parameters.

There are no user configurable elements on this screen except for the ability to set the bridge aging timeout.

Timeout ± Enter the bridge aging timeout (10±1,000,000 seconds) (Default = 300).

Card VLAN (Card) A-E-B

Gives the user the ability to configure VLANs for the entire card. There are a maximum of 16 entries per card

Item ± Enter 0 (zero) to add a new record.

VLAN ± Enter a VLAN ID between 2 and 4094 (Default = Null). There must be an entry in this field.

Mux Fwd ± Enable/Disable (Default = Enable). There must be an entry in this field.

HWhen Mux Fwd is enabled, all upstream traffic is sent out the 10BaseT interface. Forwarding restrictions are set by the other parameters on the screen.

HWhen Mux Fwd is disabled, the DSLAM forwards traffic based on a destination MAC address.

Either enabled or disabled, traffic is forwarded on ports having the same VLAN designation.

IP Filter ± Enable/Disable (Default = Disable). There must be an entry in this field.

HWhen IP filtering is enabled, the DSLAM looks at IP traffic from the subscriber to authenticate the source IP address.

HWhen IP filtering is disabled, traffic passes all protocols. This does not apply to packets that are not IP type.

IP Scoping ± Enable/Disable (Default = Enable). There must be an entry in this field.

HWhen IP Scoping is enabled, the DSLAM intercepts IP ARP and DHCP requests and responses.

HWhen IP Scoping is disabled, the DSLAM allows non-IP traffic to be forwarded.

Domain Name ± Enter the domain name of the Internet Service Provider (ISP).

Port VLAN (Port) A-E-C

Gives the user the ability to configure one VLAN association on an individual port.

DSL Port # ± Enter the DSL port number (Default = 1).

VLAN ± Number of the VLAN port (Default = none). This field is read-only.

Default NHR ± Enter the IP address of the next hop router in nnn.nnn.nnn.nnn format (Default = none). If the NHR IP address does not exist for that port, a default NHR IP address is used. If the default NHR IP address does not exist, the Address Resolution Protocol (ARP) request is ignored.

5-10 May 1998 8000-A2-GB26-00