Configuring the Hotwire DSLAM
Creating SNMP Community Strings and Enabling Authentication
Failure Traps
"Procedure
To configure SNMP community strings and enable the Authentication Failure trap mechanism:
1.From the MCC Main Menu, select
Configuration → SNMP → Communities/Traps (A-F-B).
2.If desired, enable the Authentication Trap Failure. You want to enable this field to send a trap when an SNMP request community string does not match or when the password for a Telnet session is incorrect.
3.Enter access permission at the
ReadOnly(ro)/ReadWrite(rw)/NoAccess(na): prompt.
4.Type the IP address or addresses of the NMS manager(s) in nnn.nnn.nnn.nnn format at the IP Address (nnn.nnn.nnn.nnn) or space to delete: prompt.
5.Enter the port number at the Input Number: prompt (default = 162).
6.Enable the IP address and port to send traps to this address at the
Enable/Disable: prompt.
7.Press
For additional information on this screen, see Chapter 4, SNMP Menu, in the Hotwire Management Communications Controller (MCC) Card, IP Conservative, User's Guide.
Creating the Default Route
Use this procedure to create the default route to the management domain next hop router. This default route will be used to forward management domain traffic from the MCC card.
"Procedure
To create the default route to direct management domain traffic to the MCC card:
1.Select Configuration → IP Router → Static Routes
2.Enter 0 or press Return at the Item Number prompt.
3.Enter 0.0.0.0 at the Destination (or space to delete route): prompt.
4.Press Return at the Subnet Mask:(nnn.nnn.nnn.nnn) prompt.
5.Type the IP address of the default route to the next hop address at the Next Hop IP Address (nnn.nnn.nnn.nnn) prompt.
6.Type 1 for preference at the Input Number prompt.
7.Leave default fields for S/D (Source/Destination) and PA (Proxy ARP) fields.
8.Press
May 1998 |
