Paradyne 9783 installation instructions Setting Up for In-Band Management

Configuring SNMP Trap Managers and Traps

Procedure

To enter SNMP managers and configure traps:

1.Select SNMP Traps.

Main Menu → Configuration → Management and Communication → SNMP Traps

2.Configure the following:

—Enable SNMP Traps.

—Identify the total Number of Trap Managers.

—Specify the IP address for each NMS Trap Manager to which traps will be sent.

—Specify the Initial Route Destination for each Trap Manager. The default is AutoRoute.

—Select or disable trap categories, as needed.

3.Save the configuration.

Setting Up for In-Band Management

If FRF.8 Encapsulation Mode is set to Translational, remote management of the router can still be accomplished in-band, as indicated in the following procedure.

The following procedure assumes that the router’s Ethernet interface has already been assigned an IP address that is in the same subnet as the management IP address entered in Step 6 on page 16 of Using the Easy Install Feature, and that the router is not configured for bridging only.

Refer to Configuring the FrameSaver DSL Router; CLI Commands, Codes, and Designations, and Command Line Summaries and Shortcuts in the User’s Guide for additional information.

17