Paradyne DMD15L operation manual Interface Menu Options and Parameters, ESC CH#1, ESC CH#2

DMD15/DMD15L IBS/IDR Satellite ModemUser Interfaces

Reed-Solomon (menu):	These selections are visible only when the Reed-
	Solomon Option is installed.
Enable/Disable	{Enable, Disable}
	Allows the user to Enable/Disable the Reed-Solomon
	Encoder.
RS Codes	{Refer to Appendix A for valid n/k values}
	Displays the currently used n, k Reed-Solomon Codes.
	In Closed Net Mode, the user may select custom RS
	Codes.
RS Depth	{4, 8}
	Allows the user to select the Reed-Solomon interleaver
	depth. In Closed Net Mode, a depth of 4 or 8 may be
	selected.

4.3.4 Interface Menu Options and Parameters

Tx Setup (menu):
Tx Ckt ID:	Allows the user entry of a Tx Circuit Identifier. Circuits
	can be given up to an 11 Character alphanumeric identity
	such as LINK1.
Tx Type:	{G.703, V.35, RS-232, RS-422}
	Allows the user to select the Transmit Type.
Tx Clock:	{SCTE (External), SCT (Internal), SCR, EXT CLK}
	Allows the user to select the Transmit Clock Source.
Clk Polarity:	{Auto, Normal, Inverted}
	Allows the user to select the Clock Polarity for the Tx
	Terrestrial Clock relative to the Tx Data. “Auto” detects
	wrong polarity and automatically corrects. If G.703
	Interface is selected, this selection cannot be changed.
SCT Source:	{INTERNAL (SCT), SCR (Rx SAT CLK)}
	Allows the user to select SCT Source to be either the
	SCT Oscillator or RX Satellite Clock. Rx SAT CLK is
	used for loop timing.
ESC CH#1	{+10 to -20}
	Available only in IDR Mode at a valid IDR Rate. Controls
	the volume of the ESC Channels.
ESC CH#2	See above.

TM051 - Rev. 5.8 4-11