ParkerVision WR3000 manual Introducing Web Configuration Utility, Web Configuration Utility Overview

15

®

WR3000 4-Port Wireless DSL/Cable Router

Chapter 2:

Introducing

the Web Configuration Utility

This chapter describes how to access the WR3000 Wireless Router Web Confi guration Utility and provides an overview of its screens.

2.1Web Configuration Utility Overview

The Web Confi guration Utility makes it easy to confi gure and manage the WR3000 Wireless Router. The screens you see in the Web Confi guration Utility may vary somewhat from the ones shown in this document due to differences between individual WR3000 Wireless Router models or fi rmware versions.

2.2Accessing the WR3000 Wireless Router Web Configuration Utility

Step 1. Make sure your WR3000 Wireless Router hardware is properly connected (refer to the Chapter 1 of this manual).

Step 2. Prepare your computer to connect to the WR3000 Wireless Router (refer to the Setting Up Your Computer’s IP Address appendix).

Step 3. Launch your web browser.

Step 4. Type “http://192.168.150.1” as the URL Address fi eld.

Step 5. Type “1234” (default) as the password and click Login. In some versions, the default password appears automatically - if this is the case, click Login.

Step 6. You should see a screen asking you to change your password (highly recommended) as shown next. Type a new password (and retype it to confi rm) and click Apply or click Ignore to allow access without password change.

Note - If the default password of “1234” is not accepted, refer to Section 2.3.1 on page 18 of this manual and go through the reset procedure to set all parameters back to factory defaults.

Then try the above steps again.