Models 2603, 2621, and 2635 Getting Started Guide | E • Command Line Interface (CLI) Operation |
|
|
ip interface ip1 list secondaryipaddresses <enter> |
|
Secondary IP addresses for interface: ip1 |
|
ID IP Address |
|
| |
|
In this example there was not a secondary IP address. Now save the entire configuration in nonvolatile FLASH mem- ory with the following command.
→system config save
Wait for the message that says “Configuration Saved”, then reboot the modem with this command.
→system restart
Administering user accounts
As admin user you can administer user accounts. This section summarizes the CLI commands which can be used to administer user accounts.
Adding new users
To add a new user username, use the command: system add user < username > <“Comment”>
system add login user < username > <“Comment”>
The first command creates a user who can access the system via a dialin connection using PPP for example. The second command creates a user who can login to the system.
For example, the commands:
system add user fred “user with dialin access”
system add login joe “user with login access”
creates two new users called fred and joe. The accounts are created with no passwords. To view details about the new users, enter:
system list users
The following information is returned:
Users: |
|
|
|
| |
May May Access |
|
|
|
| |
ID Name | Conf. | Dialin | Level | Comment | |
1 | fred | disabled | ENABLED | default | user with dialin access |
2 | joe | ENABLED | disabled default | user with login access | |
3 | admin | ENABLED | disabled superuser Default admin user | ||
Setting user passwords
To change the password for the user you are currently logged in as, use the command:
user password
Enter the new password twice as prompted:
Enter new password: ***
Again to verify: ***
→
Administering user accounts | 132 |
