Models 2603, 2621, and 2635 Getting Started Guide |
| 3 • Initial Configuration | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 12. Power connector location on rear panel (Model 2603/T shown)
The IPLink router power supply automatically adjusts to accept an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the CAUTION power cord into the receptacle. Failure to do so could result in
equipment damage.
3.Verify that the AC power cord included with your IPLink router is compatible with local standards. If it is not, refer to chapter 13, “Contacting Patton for assistance” on page 112 to find out how to replace it with a compatible power cord.
4.Connect the male end of the power cord to an appropriate power outlet.
5.Verify that the green Power LED is lit (see figure 13).
6.Unplug the AC power cord from the IPLink Series router to power down the unit.
Hardware installation | 35 |
