Model 2616RC T-DAC User Manual

1 • Introduction

 

 

LED display

Front panel LEDs (figure 3 on page 17) display the status of the WAN ports, the T1/E1 ports, the Ethernet LAN port, power, and the alarms. The LEDs are described in table 3.

 

 

 

Table 3. LED definitions

 

 

 

 

LED

Color

Status

Meaning

 

 

 

 

POWER

Green

On solid

Power is being applied. No action recommended.

 

 

Flashing

The 2616RC has detected a power failure on a power bus.

 

 

 

 

 

 

Off

No input power is being applied.

CPU FAIL

Red

On solid

CPU is unable to load the software from FLASH to RAM for operation.

 

 

 

 

 

 

Off

The CPU is operating normally.

ALARM

Yellow

On solid

A minor alarm condition has been detected.

 

 

 

 

 

 

Flashing

A major alarm condition has been detected.

 

 

Off

The Model 2616RC is operating normally.

SYSTEM

Green

Flashing

The Model 2616RC is operating normally.

 

 

Off

The Model 2616RC is not functioning properly.

 

 

 

 

ETHERNET

Green

On solid

Link status is nominal for the Ethernet port. No action recommended.

 

 

Off

A valid link has not been detected.

CLK SOURCE

Green

On solid

The 2616RC is set as the Master Clock source.

 

 

Flashing

The 2616RC is set as the secondary clock source.

 

 

 

 

 

 

Off

The 2616RC is set as the slave, getting its clock from the H.110 Bus.

CLK ERROR

Yellow

On solid

Master Clock source has been lost and the 2616RC is using the secondary source

 

 

 

for its clock.

 

 

 

 

 

 

Flashing

Master Clock source and the Secondary Clock source have been lost and the 2616RC

 

 

 

is using its internal crystal for its clock.

 

 

Off

No clock errors currently detected.

TEST MODE

Green

On solid

One or more T1/E1 ports or T1/E1 ports is in test mode.

 

 

Flashing

One or more of the T1/E1 ports or the T1/E1 ports is in test mode and errors have

 

 

 

been received.

 

 

 

 

 

 

Off

None of the T1/E1 ports is operating in test mode.

T1/E1

Green

On solid

The port is activated, linked, and operating normally.

CONNECTION

 

 

 

 

Flashing

The port is activated but not linked or in an error state.

(LEDs 1–16)

 

 

 

 

READY

Blue

On

Card ready for removal from Patton ForeFront chassis.

 

 

Off

Card not ready for removal from Patton ForeFront chassis.

 

 

 

 

Hardware overview

18

Page 18
Image 18
Patton electronic 2616RC user manual LED display, Led