Patton electronic M-ATA manual Dial Tone, Prompt Tone, Confirm Tone, Holding Tone, Busy Tone

SmartLink M-ATA Getting Started Guide 6 • System

To specify a 350-Hz and 480-Hz tone that will be played at 15 dB for one second and then pause for 0.5 sec- onds, you would specify:

350@-15+480@-15#ON(1000),OFF(500),R

The following example would repeat playing of a tone of 280 Hz at -8 dBm for 0.3 seconds with a pause of 0.1 second and a tone of 550 Hz for 0.8 seconds with a pause of 0.15 seconds.

280@-8+550@-20#ON(300),OFF(100),ON(800),OFF(150),R

Figure 32. Call Progress Tones section of Localization window

Dial Tone

Played when prompting the user to enter a phone number.

Prompt Tone

Played when prompting the user to enter a call forward phone number.

Confirm Tone

This should be a brief tone to notify the user that the last input value has been accepted.

Holding Tone

Indicate to the local user that the far end has placed the call on hold.

Busy Tone

Played when a 486 RSC is received for an outbound call.

Ring Back Tone

Played for an outbound call when the far end is ringing.

Off Hook Warning

Played when the subscriber does not place the handset on the cradle properly.

Localization 56