Voice Connectivity, Fax and Modem Support | Patton electronic M-ATA

SmartLink M-ATA Getting Started Guide	B • Specifications

Voice Connectivity

2-wire Loopstart, RJ-11/12 Short haul loop 1.1 km @3REN

Caller-ID Type-1/2 FSK and ITU V.23/Bell 202 generation

Connectivity

1 10/100 Full Duplex/Autosensing Ethernet RJ-45

Voice Processing (signalling dependent)

SIP

MGCP

•Packet Cable NCS 1.0

•IETF MGCP 1.0 Voice codes

•G.711 A-Law/µ-Law (64 kbps)

•G.726 (ADPCM 40, 32, 24, 16 kbps)

•G.723.1 (5.3 or 6.3 kbps)

•G.729ab (8 kbps)

G.168 echo cancellation

2 parallel voice connections DTMF detection and generation Carrier tone detection and generation Silence suppression and comfort noise Conﬁgurable dejitter buffer DTFM in-band & out-of-band Conﬁgurable transmit packet length RTP/RTCP (RFC 1889)

Fax and Modem Support

G.711 transparent FAX

T.38 Fax relay (9.6 k, 14.4 k)

Voice Connectivity

78

Image 78

Patton electronic M-ATA manual Voice Connectivity, Voice Processing signalling dependent, Fax and Modem Support

Contents

SmartLink M-ATA Mailsupport@patton.com Summary Table of Contents Table of Contents Telephony None Table of Contents System Table of Contents Documentation Calling Features List of Figures List of Tables About this guide AudienceStructure Precautions Safety when working with electricity Typographical conventions used in this document General observationsGeneral conventions Chapter contents General information SmartLink M-ATA overview SmartLink M-ATA SmartLink installation Installing the M-ATA Phone Power adapter Resetting the M-ATA to factory default Home System information System Uptime System information System Status Network-LAN Network Settings StatusInterface Status Settings Internet Conﬁguration Obtain LAN conﬁguration dynamicallySpecify ﬁxed LAN conﬁguration Settings Enable PPPoEAuthentication WAN PPPoE Conﬁguration WAN MAC Address Spoofed Conﬁguring Dynamic DNSMAC Spooﬁng Conﬁguration Vlan Conﬁguration Priority Tag Ieee 802.1q ToS/DiffServVlan Tag Ieee 802.1q Saving your work Telephony Telephony Telephony VoIP Status VoIP Server Registration StatusPhone Line Status Subscribed for Voicemail Caller ID SettingUser Name Messages waiting SIP Server Settings Gateway SettingsSIP Conﬁguration SIP Extensions RTP Telephone Event ConﬁgurationVoIP Vlan Conﬁguration Hook Flash Mime Type SIP Timer Values millisecondsSIP Parameters RTP Parameters NAT Traversal Jitter Buffer Audio/CODEC ConﬁgurationPacketization FAX without T.38 Use G.711 fax Phone User Information Supplementary Service Activation Call Transfer Message Waiting IndicatorDistinctive Ring Dialing by IP Address Call Forward Settings Dial Out Type Selective Call Forward Settings Incoming Call BlockOutgoing Call Block Speed Dial Http Digest SettingLine 1 Speed Dial Settings Speed Dial Serv System System System New User Password Set Security PasswordNew Root Password Conﬁrm new password Conﬁguration Syslog ServiceEnable Syslog Syslog Server NTP Service Debug ServiceEnable Debug Debug Server Enable Http Service AccessTime Zone Adjust clock for daylight savings Enable Ping Reply Localization Call Progress Tones Conﬁrm Tone Dial TonePrompt Tone Holding Tone Distinctive Ring Settings Following is a sample ring cadence pattern conﬁguration Block Anonymous Calls Supplementary Service KeysCall forward selective Warm Line Income Caller ID IP DialingSpeed Dialing Calling Preﬁx Keys Call Conference Call HoldCall Waiting call alternative Call Conference Drop Control Timer Values FXS Port Ring Setting FXS Port Polarity Conﬁguration Snmp Community Conﬁguration Snmp ConﬁgurationSnmp Trap Conﬁguration Snmp System Conﬁguration Auto Upgrade Manual Upgrade Manual Upgrade window Reload Documentation Introduction Documentation link Logout Logout window Contacting Patton for assistance Contact information Patton support headquarters in the USA Warranty coverage RMA numbers Appendix a Compliance information Radio and TV Interference FCC Part Safety ComplianceCompliance CE Notice Declarations of Conformity Appendix B Speciﬁcations Connectivity Voice Processing signalling dependentVoice Connectivity Fax and Modem Support Management Voice Services/FeaturesIP Services Operating Environment Appendix C Dial plans Non-dialed Line Dial Plan Sample Dial PlansSimple Dial Plan Complex Dial Plan Sample Dial Plans Appendix D Calling Features Distinctive on Distinctive OFF Appendix E Voice prompt conﬁguration Accessing the voice prompt Existing voice prompt conﬁguration