Pelco TLR2096 operation manual Recording SET UP Menu, Rear Terminal Menu

<RECORDING SET UP>
)ALARM REC MODE	2H
ALARM REC DURATION	1M
EMERGENCY REC	OFF

Figure 12. Recording Set Up Menu

NOTE: Set the ALARM REC DU- RATION to MAN2 to use with the MX4000 Series Genex™ Multi- plexer.

NOTE: When using the MX4000 Series Genex™ Multiplexer, make sure the EMERGENCY REC set- ting is ON if the VCR is to record alarms only.

6.7 RECORDING SET UP MENU

ALARM REC	Sets the alarm recording mode. When you turn the JOG dial, the
MODE	display switches in the following order: 2H, 6H, L18H, 2H.
	(Refer to Section 8.3.3 for programming instructions.)
ALARM REC	Sets the length of the alarm recording period. When you turn the
DURATION	JOG dial, the display switches in the following order: 1M
	(minute), 2M, 5M, 10M, MAN1, MAN2, 15S (second), 30S, 45S,
	1M. (Refer to Section 8.3.3 for programming instructions.)

EMERGENCY REC Sets the emergency recording mode, as follows:

•OFF – Starts alarm recording when the alarm signal is received during recording.

•ON – Starts alarm recording when the alarm signal is received, not only during recording but also when the power is OFF or when the tape is stopped.

Refer to Section 8.3.3 for programming instructions.

<REAR TERMINAL>

)CALL OUT WRNG•TAPE END

CLOCK OUT	REC-1
MODE OUT	REC
REC IN	SERIES

Figure 13. Rear Terminal Menu

6.8 REAR TERMINAL MENU

CALL OUT	Sets the call signal output at the end of the tape. Turns on or off
	the signal that comes from the CALL terminal when the end of
	the tape is reached during recording. If any problems occur
	during recording, a call signal is output from the CALL terminal
	on the rear panel regardless of the CALL OUT setting.
	• WRNG•TAPE END– A signal is output at the end of the
	tape or when a malfunction occurs.
	• WRNG•REMAIN– The signal is output when a malfunc-
	tion occurs in the VCR or when the tape has about three
	minutes left in 2H mode.
	• WRNG – When a malfunction occurs in the VCR during
	recording, a call signal is output.
	CALL OUT is used in conjunction with TAPE END (First Time
	Set Up menu) to determine when the call signal is output, as
	shown in Table B.

Table B. Call Out/Tape End

		CALL OUT
TAPE END		Setting	WRNG•TAPE END	WRNG•REMAIN	WRNG
Setting
		STOP	Outputs a call signal at the	Outputs a call signal three minutes	When a malfunction occurs in the VCR
			end of the tape	before the end of the tape	during recording, a call signal is output.
	REWIND		Outputs a call signal at the	Same as above	Same as above
			end of the tape for 2 seconds
	REPEAT		Same as above	Same as above	Same as above
	When there are no
ALARM	alarm recordings		Same as above	Same as above	Same as above
		during recording
• PROT
	When there are no		Outputs a call signal at the		Same as above
	alarm recordings			Same as above
			end of the tape
	during recording

24 Pelco Manual C651M (7/99)