5.3 REAR PANEL
WARNING: The included power cord is used for 120 VAC, 60 Hz. Never connect the power cord to any outlet or power supply having a different voltage or frequency.
1 | 2 4 6 9 A | |||||||||
|
|
| 3 | 5 | 7 8 |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SET RST REC GND ALM MODE |
| CLK CALL | |||||
| IN |
|
|
| OUT |
| RESET |
|
|
|
| ||||
|
|
|
|
|
|
| |
ÉMIC
INOUT
AUDIO
REMOTE
IN | OUT |
| VIDEO |
|
| G F E | D C B |
| NOTE: Make sure the power cord is unplugged before making any rear terminal connections. | ||
1. | AC power socket | 8. | CLK (clock) OUT terminal |
| The power cord plugs into this socket. Insert the cord firmly. | Output terminal to control an external camera switcher, such | |
|
|
| as the MX4000 Series Genex™ Multiplexer. |
2. | SET IN terminal |
|
|
(Alarm) input terminal to start alarm recording. Connect the alarm sensor here.
3.RST (reset) IN terminal
Input terminal to stop alarm recording when ALARM REC DURATION in the Recording Set Up menu is set to MAN1. Connect the alarm reset switch here. You can also use this terminal to set the
4.REC IN terminal
Input terminal to start/stop recording. You can also use this terminal for series recording (refer to Section 8.1.5) or syn- chronous recording (Section 8.1.6).
5.GND (ground) OUT terminal
Connect the ground lead here when a lead connected to other terminals requires a ground.
6.ALM (alarm) OUT terminal
Output terminal to an external device to indicate an alarm is being recorded.
7.MODE OUT terminal
Output terminal to indicate the VCR’s mode of operation, which can be selected by setting the MODE OUT in the Rear Terminal menu.
9.CALL OUT terminal
Output terminal to indicate when the tape has finished re- cording or that there was a problem during recording.
10.RESET button
Press to erase the present time, alarm recording list, power loss list, and the number of tape uses. Power to the VCR is cut off while the button is pressed. If there is a tape in the VCR and the button is released, the power indicator will light and the tape will fast forward for a few seconds. The VCR will then turn off.
11.REMOTE jack
The remote control unit is not supplied.
12.VIDEO OUT connector
Output connector for video signal (BNC connector).
13.VIDEO IN connector
Input connector for video signal (BNC connector).
14.AUDIO OUT connector
Audio output connector (RCA pin).
15.AUDIO IN connector
Audio input connector (RCA pin).
16.MIC IN jack
Input jack for a microphone rated at
Figure 5. Rear View
Pelco Manual C651M (7/99) | 17 |
