Pelco TLR2096 operation manual First Time SET UP Menu, Day And Time Display Modes

POWER LOSS	Turn the SHUTTLE ring to the right and the words POWER
LIST CLEAR	LOSS LIST CLEAR will be displayed. When you turn the
	SHUTTLE ring to the left, the list will be cleared. Turn the
	SHUTTLE ring to the right to return to the Maintenance menu.
ALARM LIST	Turn the SHUTTLE ring to the right and the words ALARM LIST
CLEAR	CLEAR will be displayed. When you turn the SHUTTLE ring to
	the left, the list will be cleared. Turn the SHUTTLE ring to the
	right to return to the Maintenance menu.

6.10 FIRST TIME SET UP MENU

<FIRST TIME SET UP>
)TAPE END	STOP
QUASI V-SYNC	ON
TAPE LENGTH	T-120
TIME DATE ADJUST

Figure 15. First Time Set Up Menu

NOTE: Some multiplexers may re- quire Quasi V-Sync OFF to work properly. With the Pelco MX4000 Series Genex™ Multiplexer, setting Quasi V-Synch on or off has no apparent effect on playback.

TAPE END	Sets the VCR’s state of operation when the tape runs out during
	recording.
	• STOP– The tape stops. “End” appears on the fluorescent
	display and “Tape End” on the monitor. When CALL OUT
	is set to WRNG•TAPE END, a call signal is output from the
	CALL terminal.
	• REWIND– Rewinds the tape to the beginning and stops
	(except during timer recording). When CALL OUT is set to
	WRNG•TAPE END, a call signal is output for two seconds
	from the CALL terminal.
	• REPEAT - Rewinds the tape to the beginning and re-
	sumes recording.
	• ALARM•PROT– (Alarm Protection) If alarm recordings
	are on the tape, then the tape stops. “End” appears on the
	fluorescent display and “Tape End” on the monitor. When
	CALL OUT is set to WRNG•TAPE END, a call signal is
	output from the CALL terminal. If there are no alarm
	recordings, the tape is rewound and recording continues.
QUASI V-SYNC	Sets Quasi V-Sync on or off.
	• ON– Quasi V-Sync signal is inserted on the video output
	signal when in the special playback modes (still, slow
	motion, reverse, fast playback, speed search) and during
	normal playback in L18H, 72H, or 96H modes.
	• OFF- Quasi V-Sync signal is not inserted.
TAPE LENGTH	Sets the tape length to match the tape so the tape remaining
	indicator works correctly. Set as follows:
	• T-120– When using T-120 tape.
	• T-160– When using T-160 tape.
TIME DATE	Sets the time, date, and Daylight Savings setting. Section
ADJUST	6.10.1 provides an explanation while Section 6.10.2 provides a
	procedure.

12 3 4

01-01-97 00:00:00 A0001

Figure 16. Display Mode 1

6.10.1 Day And Time Display Modes

Display Mode 1

1.Month-Day-Year

2.Hour:Minute:Second

3.Daylight Savings Time symbol or power failure symbol

4.Alarm recording number

•A 24-hour display is used: 00:00 indicates midnight; 12:00, noon; and 15:00, 3 p.m.

•An alarm recording number is displayed during alarm recording.

26 Pelco Manual C651M (7/99)