Pelco TLR2096 operation manual Record Check Function, Audio Recording, Repeat Recording

<MAINTENANCE > )POWER LOSS LIST

ALARM LIST

ALL MENU INITIALIZE POWER LOSS LIST CLEAR ALARM LIST CLEAR

<REPEAT REC TIMES>	0
<ELAPSED TIME>	0H

8.1.2 Record Check Function

When the VCR is recording, press the PLAY button for more than 1.5 seconds and then release. The tape rewinds a little and then plays back the recording just made. When the tape reaches the spot where you pressed the PLAY button, the VCR returns to record mode.

8.1.3 Audio Recording

Either apply the specified line input signal to the AUDIO IN connector or connect the microphone to the MIC IN jack. If both are connected, the microphone is given priority.

Normal sound is played back only when a tape recorded in 2H, 6H, or L18H mode is played back in its respective mode.

The longer the recording time mode, the worse the sound quality becomes. In L18H mode, the sound quality is such that speech can be heard.

8.1.4 Repeat Recording

When TAPE END on the First Time Set Up menu is set to REPEAT or ALARM•PROT and the repeat recording mode is set (the REPEAT indicator is lit), the tape will automatically rewind to the start when the end of the tape is reached. Recording will begin again.

Table D shows what automatically happens when the tape ends during recording.

8.1.4.1Number Of Tape Uses (Repeat Recording Times)

Displays the number of times a tape has been used when the TAPE END setting is set to REWIND, REPEAT, or ALARM•PROT.

1.Press the DISPLAY button. The Main menu will appear.

2.Turn the JOG dial to select MAINTENANCE and turn the SHUTTLE ring to the right. MAINTENANCE will appear on the display. REPEAT REC TIMES indi- cates how many times a tape has been recorded on.

•The number of tape uses increments by one when the tape ends.

•The number of tape uses is kept even if the AC power is disconnected, provided the backup battery is fully charged.

•The number of tape uses is reset when you replace the current tape with another.

3.Press the DISPLAY button. The time will be displayed.

NOTE: On ALARM•PROT mode, a tape with alarm recordings can be used for repeat recording by ejecting and re-inserting the tape.

Table D. When Tape End Is Reached

	STOP	REWIND	REPEAT		ALARM•PROT
When there are	The tape	The tape rewinds	The tape rewinds		The tape stops
alarm recordings	stops.	automatically to	automatically to
on tape.		the beginning and	the	beginning
		then stops.	and	recording
			resumes.
When there are no					The tape rewinds
alarm recordings					automatically to
on tape.					the	beginning
					and	recording
					resumes.

Pelco Manual C651M (7/99) 31