3Important
ACaution!Visible and invisible laser radiation. If the cover is
open, do not look at the beam.
Because of the risk of eye injuries,only qualified service
engineers should open the device and carry out
maintenance or repair work.
ALASER
Typ: Semiconductor lasers InGaAlP (DVD), AlGaAs(CD)
Wavelength: 660nm (DVD), 780nm (CD)
Output power (outside the lens): 20mW (DVD+RW write),
0.8mW (DVD read), 0.3mW (CD read).
Beam divergence: 82 degrees (DVD), 54 degrees (CD)
ADanger.High voltage! Do not open.
Do not insert objects into the ventilation slots and fan
openings!
You run the risk of getting an electric shock.
AThedevice does not contain any user-serviceable parts. Please
leave all maintenance work to qualified personnel.
AThereare some components in the DVD recorder that keep
running as long as the recorder is connected to the power supply.
To switch off the DVD recorder completely, you must unplug it
from the power supply.
AIfyou disconnect the DVD recorder from the mains, make sure to
take the plug out of the wall socket and not just remove the
connector from the 4MAINS Jsocket at the back of the unit.
Children playing near the device could suffer injuries at the free
end of the cable.
AMakesure that air can circulate freely through the ventilation slots
on the side and the fan opening at the back of the device to avoid
overheating. The device should be placed on a firm surface.
ADonot insert any objects into the openings or ventilation slots of
the device.
CThese operating instructions have been printed on non-polluting
paper.
CPlease dispose of old batteries safely.
CPlease take the packaging to your local recycling center.
CThis electronic equipment contains several materials that can be
recycled. If you are disposing of an old device, please take it to a
recycling center.
BDonot switch on the device immediately after transport from
a cold to a warm room or vice versa, or under conditions of
extreme humidity.
Wait at least three hours after transporting the device. The DVD
recorder needs this time to acclimate to itsnew environment
(temperature, relative humidity, etc.).
BWheninstalling the recorder in a cupboard, ensure there is a gap
of approximately 5 cm (2 inch) around the recorder to enable air
to circulate freely and prevent overheating.
BMakesure that no objects or liquids enter into the DVD recorder.
Do not place vases or the like on the DVD recorder. If you spill
liquid into the recorder, immediatelydisconnect it from the power
supply and call after-sales service for advice.
BKeepthe DVD recorder away from radiators and other heat
sources and protect it from direct sunlight.
BDonot place any combustible objects on the device (candles, etc.).

Important instructions for the HDD

The built-in HDD of this DVD recorder is sensitive to shocks,
temperature fluctuations, and vibrations.
DO NOT MOVE THE SET WHEN SWITCHED ON !
because the HDD is always running andcan be damaged.
Please observe the following precautions:
BAvoidshocks or vibrations
BDonot cover the ventilation openings of the cooling fan
BDonot operate the device under high temperatures, and do not
expose it to temperature fluctuations
BDonot pull the mains plug from the wall outlet before the device
is switched off using STANDBY m2.
BBeforebringing the device to a workshop for repair, store all
important data of the HDD on a DVD+RW,DVD+R. See 'The
archive function'.
The workshop will not assume any liability for the loss of the
stored data.
BPhilipswill not assume any liability for damage or loss of
stored data.
Warnings/information