101
PROBLEM/HINTS SOLUTION
The wrong TV channelwas decoded(recorded) after youprogrammed arecording usingShowView System.
bThe programmenumber of the TV channel is not available in the GUIDE Plus+®system or allocation is
wrong.
To change or check the channel data, proceed as follows:
1Press GUIDE/TV J.
2Press AI.
3Select 'Editor' with CM.
4Select the TV channel using BOor AI.
5Press CMto go to the right tile.
In case you can receive the selected channel only via an externalreceiver, press the red
button to select the corresponding source.
6Press the green button.
7Enter the programme number of the TV channel using the number buttons.
If the source you have selected is an external receiver, enter the programmenumber that you
would also enter at the external receiver for this TV channel.
8Confirm with OK L.
bIf no GUIDE Plus+®data is available,enter the right programme number after you have confirmed the
ShowView programme number using OK L.
TV channels will bedeactivated in theGUIDE Plus+®Systemafter 24 hours
bThis happens occasionally. To switch on the channels proceed as follows:
1Press GUIDE/TV J.
2Press AI.
3Select 'Editor' using CM.
4Select the TV channel using BOor AI.
5Press DKto select the left row.
6Switch on the TV channel using the red function button D.
7End with GUIDE/TV J.
No 'VPS/PDC time' in
the GUIDE Plus+®
System
bThe GUIDE Plus+®Systemjust shows the start time. The 'VPS/PDC' time will be taken into account.
There is no channeloverview in the GUIDEPlus+®system
bDVD recorder is switched on: Switch off the DVD recorder to allow data transfer
bThe TV channel that transmits the GUIDE Plus+®data is not set properly.
bExternalreceiver (satellite receiver, set-top box, cable TV box, ...) (if available) is switched off: switch on the
external receiver
bG-LINK cable is not connected: Connect the G-LINK cable and make the necessary settings to control the
external receiver (see chapter 'The GUIDE Plus+®System', section 'Installation of the 'External receiver
1').
bCheck that your externalreceiver (if available) sends out teletext data through the scartcable.
Connect therefore the scartcablefrom the external receiver directly to the TV set and call up the teletext
function on the TV set from a TV channel that transmits teletext data. If no teletext appears, your external
receiver can not be used for the GUIDE Plus+®system.
Missing or wrong TVchannel in the 'Grid'screen
bWrong local post code/country was entered
bPleasecheck your correct channel line up in the 'Grid' screen.
Read therefore the section 'The 'Editor' screen.
When you pressGUIDE/TV JtheGUIDE Plus+®setupscreen will appear
bThe GUIDE Plus+®systemwas not completely installed or local post code was not entered.
1Check the settings
2Select the corresponding line using BOor AIand confirm with OKL.
3For more information on the individual functions, see chapter 'The GUIDE Plus+®system',
section 'Setting up the GUIDE Plus+®System'.
Before you call an engineer